Fuel problem. 95/96 xj6. 3.2 sport

no cut off or inertia switch

thats a very long list -----check and test inertia switch ---have vehicle scanned for any trouble code[s] ---- need to find out if its fuel or electrical ---check and test fuel pump ---not working have fuel problem ----if fuel but no spark -- then elect problem -----if have both then possible timing chain skipped or failed

The inertia switch is located on the toe-board, to the right of the transmission hump, in the passenger-side footwell.
https://www.autozone.com/repairguides/Mazda-B-Series-1998-06/Gasoline-Fuel-Injection-Systems/Inertia-Fuel-Shut-Off-Switch/_/P-0996b43f8037717d

Kill switch ????? It's called inertia fuel shut off switch . Unless you were in a accident the chance the fuel shut off switch being your problem is astronomical . If the vehicle doesn't start , checking for spark an fuel pressure and compression to find the cause of the no start problem . Given the year of the vehicle it could need a new fuel pump or fuel pump relay . If the vehicle isn't getting fuel ,viewing a wiring diagram for the fuel pump electrical circuit an testing with a DVOM - digital volt ohmmeter is the proper way to diagnose . But just to answer your question the inertia fuel shut off switch is located
According to the 2003 Ford Escape owners manual : The fuel pump inertia switch ( shut off switch ) is located in the front passenger footwell , behind a flip up cover , near the right kick panel access. Just push the button .If it was tripped it will click when pushed .

sounds like a bad cam/crank sensor, or bad inertia switch. Ford trucks usually have a switch on the inside firewall that shuts off fuel pump in the event of a wreck. These switches go out occasionaly and will not allow vehichle to start

You likely tripped the Fuel Shut-Off Inertia Switch.
The inertia switch is located behind the trim on the right-hand
side of the vehicle, forward of the front door post, below the
fascia. Pull open the small panel in the trim to reset the switch.
Resetting the switch
CAUTION !!!:
To avoid the possibility of fire or personal injury, do not
reset the inertia switch if you see or smell fuel.
If no fuel leak is apparent, reset the inertia switch as follows:
Press the button!
If the switch was activated by the accident, you should feel it "click" when you reset it by pushing it.

Happy Motoring!

For details regarding fuel pump and fuel pump switch click the link below:--- http://technoanswers.blogspot.com/2011/06/where-is-fuel-shut-off-switch-on-1993.html This switch is also called inertia switch For fuel pump reset switch location and diagram click this link below:--- http://technoanswers.blogspot.com/2011/06/fuel-pump-reset-switch-location.html ---------- This should help.Thanks.Helpmech.

Fuel Injected Engines

If the vehicle is equipped with a pressure relief valve, install an EFI/CFI fuel pressure gauge T80L9974B or equivalent and depressurize the fuel system. If the vehicle is not equipped with a pressure relief valve, the fuel filter connection should be covered with a shop rag or towel to prevent the fuel from spraying during the removal procedure. It is also possible to reduce the amount of pressure in the fuel system by locating the inertia switch (usually located in the luggage compartment) and disconnecting the electrical connection on the inertia switch. Next crank the engine for 15 seconds to reduce the system pressure

Can I see photos

In the fuse box, (under the hood), lower right corner. C1051....if you think its bad, there are others like it in the fuse box you can swap with. If the fuel pump doesnt work, be sure to check the INERTIA SWITCH. I cant tell you how many fuel pumps are replaced because no one checked that switch. If the Inertia Switch is good, have someone rap on the bottom of the fuel tank while you are cranking the engine over, if it starts then, the fuel pump is bad.