Question about 2005 GMC Sierra

1 Answer

Replaced 02 sensor with code 131 and 171 now getting p0053

2005 gmc sierra 1500 5.3 V8. was getting rough idle. codes p0131 p0171 and p0300. changed plugs and wires and bank 1 o2 sensor 1. everything was fine for a week and now it is throwing p0053. any ideas?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • GMC Master
  • 21,873 Answers

Code 53 is for a problem with the heater in the O2 sensor for bank one sensor one. It could be something in the wiring or you could have a defective sensor.

Posted on Jan 13, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
dennymulford
  • 1055 Answers

SOURCE: engine wont idle

replace the timing gear its wore out

Posted on Feb 18, 2009

66 chrgr
  • 1011 Answers

SOURCE: SOILED PLUGS

171 is a lean bank one check for vacuum leak at the intake manifold

Posted on Mar 13, 2009

Outofworkjoe
  • 216 Answers

SOURCE: rough idle

Yes bad o2 sensor,check for vacuum leaks also.do you cross your plug wires?

Posted on Jun 26, 2009

  • 70 Answers

SOURCE: CHECK ENGINE LIGHT IS ON, GOT CODES P0157 2 TIMES,

the bank 2 sensor2 is used to check that your catylitic converter is working on that side of the exhaust. without seeing the car and doing sensor tests, it would be a gamble to say replace the sensor. so you can replace it and see what happens or take it to your favorite shop for further diagnosis

Posted on Dec 02, 2009

  • 2926 Answers

SOURCE: My 2003 GMC Sierra Idles Rough And Cut Off

Before replacing the O2 sensors, I would check the fuel pressure. You may also try to have someone pull a trouble code from the powertrain control module to verify why the engine light is on. Do not replace any parts until this is done, otherwise your going to be guessing at the root cause, and it will get expensive with part replacement.

Posted on May 12, 2010

Testimonial: "Trouble code P0101 {Mass Air Flow}and code P0332 Knock Sensor.Thanks i saved a lot money."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 Durango 3.6. Just paid dealer to replaced sensors, P000A, P0017, P00455. Now less than 500 miles getting P0131, P0300, and P0171..Starts good, idles lil ruff, starts out ruff. drives smooth.


These codes indicate a vacuum leak is likely on the left side of the intake manifold. Check any vacuum hoses there and for bad intake gaskets.

Jun 12, 2017 | Dodge Durango Cars & Trucks

1 Answer

5.3 liter Chevy engine #1 Cylinder not firing at idle


My opinion...

Year? Miles?

There's no way I'd dive into a "HEAD GASKET"
diagnosis without pressure testing the cooling
system and (wet/dry) COMPRESSION testing
the whole engine...

Even if it is a "HEAD GASKET"... the entire engine
might be ready for a REFRESH... and tossing a new
Head gasket into a TIRED ENGINE not insubstantial
(a lot of wasted time & money)...

Come back with some compression numbers...

but don't bother with any of this if your engine oil has water in it.

(in my opinion)

Carnac the Magnificent

Apr 04, 2017 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

2002 gmc sierra p0171 p0174 p0300 oygen sensor and misfire codes


Check for vacuum leaks to start. Then check the evap system. I just replaced a evap vent solenoid on a suburban with the same codes. fixed the problem.

Apr 17, 2011 | 2002 GMC Sierra 1500

2 Answers

98 chevy s-10 codes p0131, p0171, and p1133


Your O2 sensor is starting to go bad .recomend replacement before it gets worse

Sep 24, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

3 Answers

2001 GMC Jimmy Idling rough


HI
P0300 is multiple misfires.
P0171 is lean burn on left bank 1 means drivers side
02 sensor is faulty. Your vehicle is over fuelling that is why your are getting P0300 code and the rotten egg smell. Good idea is to replace both 02 sensors.

Apr 04, 2009 | 2001 GMC Jimmy

3 Answers

Codes 1133-0131-0171-0300


p1133 - o2 sensor, Insufficiant Switching, Bank 1 Sensor 1.
p0131 - o2 sensor circuit, low voltage, bank 1 sensor 1
p0171 - Lean condition, Bank 1
p0300 - Random Misfire

I would be looking at the front passenger side oxygen sensor for issues. It may be bad, it may not be plugged in, bad wiring at harness.

The random misfire may be symptomatic of the o2 sensor problem.

Mar 17, 2009 | 2002 Chevrolet Silverado 1500

2 Answers

SOILED PLUGS


171 is a lean bank one check for vacuum leak at the intake manifold

Mar 12, 2009 | 2003 GMC Sierra 1500

Not finding what you are looking for?
2005 GMC Sierra Logo

Related Topics:

397 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...