2001 toyota Prerun/tacoma automatic transmission engages slowly

SOLVED: Toyota highlander shift lever moves freely but - Fixya

https://www.fixya.com > ... > Toyota > Highlander
Sept 2, 2019 - First off, set the parking brake, raise vehicle so you can get under it. Remove the shift linkage from the transmission and manually move the shift lever to ...
I have a 2002 Toyota Echo. The end of the gear - Fixya
Oct 24, 2008
SOLVED: My 2001 toyota highlander will not shift into - Fixya
Sept 1, 2019
Transmission gear shift got stuck in Drive not able to move
Nov 20, 2019
Toyota sequoia gear shift lever broken - Fixya
Nov 16, 2019
More results from www.fixya.com

2001 V6 Highlander - Transmission Cable issue? - Toyota ...

https://www.toyotanation.com > forum > 816897-2001-...
Jun 9, 2014 - The shift lever moves VERY freely, but will not engage or come out ... It's probably a broken shifter cable , the joint at the transmission ...

Car in park shifter will move through gears but wont shif...

https://www.yourmechanic.com > Questions
Jul 13, 2016 · 1 answer
From what you've described, it sounds like the shifter cable came off at the transmission or the shifter. I'd suggest checking the shift ...

Automatic Transmission Problems Shifting Gears - Ira Toyota ...

https://www.toyotaofmanchesternh.com > automatic-tra...
One reason why an automatic transmission isn't shifting into gear has to do with the fluid. If it's not at the right level or the incorrect type has been used, ...

The system can be scanned for faults, it will take the dealer to do the testing as a special scan tool is needed to read the information..

Probably the front hubs. Engage FWD drive very slowly get someone to walk and listen for noise from the hubs or remove and check.

no miles specify but you need a cluth job.

try this website.http://manualspace.com/manual/search/automatic-transmission-dipstick-location-2002-tacoma.htm

just a guess but I would say on the side of the transmission, bolted into the bell housing as to engage the flywheel. probably the driver side.

Sounds like one of your hubs is sticking and not engaging. You can check them by engaging the hubs and the transfer case and jacking up each front wheel independently if it doesn't spin your good, if it does you found your problem. As far as fixing a hub goes, it may be just dry and need some grease, or there are some very good aftermarket hubs available from Warn.
Hope this helps

96 toyota tacoma not start with the start cancel switch push in.

First be sure transmission is in neutral , let off brake to be sure vehicle will not roll , engage 4 wheel and it will lock up .....

Your starter drive is staying engaged. Either the starter has failed, or your ignition switch is keeping the starter engaged. Try moving the key back from "start" while the noise is occurring. More than likely, the starter is the culprit.