The keyless entry system has the following main components:
• The transmitters
• The passenger door module (PDM)
The PDM communicates with the body control module (BCM) through the keyless entry serial data circuit. When you press a button on a transmitter, the transmitter sends a signal to the PDM. The PDM sends a request to the BCM and the BCM performs the appropriate function.
SOURCE: Low and High Beams not working on 1999 GMC Yukon
I would remove the remote start some cars wont register the remote start with the computer then the computer can do some crazy things its a biglist of problems it can do
SOURCE: Keyless remote Problem for Yukon Denali 2005
Have your dealership test the remotes for you, they will also use a "Tech-2" to re-program it and should not charge you to do so. "I know mine does not" The "puddle" lamps come on when you un-lock the doors with the remote."If they are enabled in the options on your dash information center or "DIC". "See owners manual for info on that". As far as the DRL's make sure your bulbs are good because they are known to blow out. But the remote should not have anything to do with those.Hope that helps a little?
SOURCE: 2005 yukon denali, a/c worked fine until battery died
Turn ignition switch ON then OFF then depress and release gas pedal 5 times to reset the computer. Worked for me.
SOURCE: I changed batteries in my 2003 GMC Sierra key fob
1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
548 views
Usually answered in minutes!
×