Drivers door on p38 super locked how do i open it

There is a sequence of left and right turns of the key in the driver's door that will reset your bECM (Rovers brain) if the following have been tried.
1. Replace batteries in remote and 're-sync by depressing lock button on remote while physically turning and locking the door. Don't release button until locked and key removed. Repeat for unlock button.
2. Disconnect negative/earth cable from battery. While disconnected open driver's door, turn ignition to position 2, return to battery leaving driver's door open and reconnect the negative cable. Proceed to ignition. Turn off completely. Close all doors and hood and attempt starting.
Should both of these methods fail, run a search here on fixya for "engine disabled Range Rover P38" This will take you to step by step instructions on resetting the bECM which I opened this post with. It has been covered many times here, including by myself, no reason to post it again.
Good Luck!

I have the same problem sometimes
1 Check the condition of your battery, if old, it will not give full power required to communicate with the security system.
2 If you don't have the EKA of your RR, try this next time you get caught, put key in the drivers door look, press unlock button on key fob and at the same time turn to unlock, if all locks unlock then the engine should not be immobilized - Good luck

Lock doors with the key. Take out key . Insert key open and close lock 5 times then on the fifth turn open door this will reset the disable code to normal . I had this code on my P38 Range Rover and the Rover Tech assisted me with this simple way to reset the engine disable fault code . Good Luck .

Check the batery in your remote

Remove door panel and inspect mechanism. Latch at lock end most probably broken.

its a convenience sensor have a dealership take a look at it its a range rover these things are made for people with money and the australian outback

souds like you either have a broken wire in the door or the motor that controls that lock is bad

check releys

CLIP OFF COVER ON DOOR HANDEL /REMOVE BOLTS FROM HOLES IN HANDEL/ PUSH UP ON PLASTIC RING ON WINDOW WINDER NOW PRISE OPEN DOOR PANEL FROM DOOR.

click on link. fixed my locks!
http://www.ford-trucks.com/forums/447449-power-door-locks-fixed.html