Side mirror replacement

not exactly same steps but similar. Most cars I have worked on the screws were along the bottom and on the arm rest. Make sure you remove all screws some may be under a access panel. Use caution when pulling on clips

Replace Your Car Passenger Side Mirror - How To - DIY ...

? 3:46
https://www.youtube.com/watch?v=77lBQ_CRqdo
Apr 10, 2012 - Uploaded by GregHint
See how even a novice can repair a passenger mirror on a FordEscape. ... Replace Your Car Passenger Side Mirror - How To - DIY .... Replace 2003-2008 Toyota Corolla Side Mirror, How to Change Install 2004 2005 2006
About 22,000 results (0.61 seconds) Search ResultsHow-To: Replace Ford Fusion side mirror (HD) - YouTube? 7:27https://www.youtube.com/watch?v=iGHeXUbvvJsMay 7, 2014 - Uploaded by Derrick HardingFord Fusion SEL 3.0 Liter V6 How to fix broken side mirrorIncludes: ... Published on May 7, 2014 ..... Great instructions - just replaced the driver's side mirror on my 2007 Fusion following your instructions. ... Front brake pad replacement 2006 - 2012 Ford Fusion Lincoln Mazda Pads Rotor Install Remove ...

remove inner arm rest and and panel take three bolts out of back side of mirror and disconnect connector reverse install

From inside car, remove plastic mirror plate, then remove the 3 screws that hold on mirror.

Removal and Installation
Remove the trim panel. Release the clip. Release the locating tabs.
Remove the trim panel. Disconnect the exterior mirror control switch electrical connector.
Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the electrical connector.
Remove the exterior mirror. Remove the bolt. If equipped, remove the screw.
To install, reverse the removal procedure.

Most auto parts store have replacements with self adhesive tape on the back. Peal and stick, just remember to clean the surface good. Also, they may need to measure the passenger mirror to give you the correct size.

no the door pannel does not need to come off but there is a triangle shaped plastic trim pannel above the door pannel that needs to be removed to access the mounting bolts.

buy removing door panel

If you are replacing the entire mirror assembly you have to remove the door panel.

First remove the switch plate by prying upward at the rear of the switch plate and unhook the connectors. Then remove the two armrest screws. The door panel then has to be pryed away from the door to release the clips. They don't give up easily so yo may have to force it a bit. Once the clips are loose pull up on the panel to remove it from the window reveal molding. The mirror is held on with three 10mm nuts. remove those and unhook the wiring from in the door. Install is reverse of removal.

Good Luck

had to install a driver side non folding mirror, fairly simply to say the least. There's a cover on the interior of the door, near the window, remove the cover, remove the 3 screws, need i believe a 10mm socket. If a power window, unhook the circuit. Replace new mirror.