MY 2000 Saturn LS2 (i think its ls2, it has a v6 engine), has th service light with the wrench on and the brake lights are not working. No fuses are blown out and all bulbs are working fine. I took it too the mechanic yesterday and the guy said I have a short and need to replace the whole taillight assembly on each side, which will be about $130 a side. Could the problem be something else like the brake switch? Also, where could I get a tail light assembly? Is it easly to install myself?
None of the brake lights work , the center high mount lights too ! I can't believe both tail lamp assembly's going bad at the same time ! Wrench light on means codes are stored in the BCM , did your Mechanic check codes .
SOURCE: 2000 Saturn ls2 Coolant leaking into car on passenger side
Your heater core is in need of replacement.
SOURCE: none of my taillights work in my 2000 saturn ls2.
sorry i cant be more specific but you definitly have a bad ground issue
SOURCE: why do my 2000 saturn ls2 keep back fireing
Hello
The engine
and automatic transmission in this vehicles drive train
are fully electronically controlled by a computer called the PCM
(Power Train Control Module). Whenever a problem like this occurs the
computer stores a record of the problem (there are of course some
exceptions to this, like the fuel pump, engine coolant temperature
sensor and MAF sensor for instance) in the form of a fault code in
its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A
TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR
HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
155 views
Usually answered in minutes!
×