2008 Mazda Tribute Logo
Anonymous Posted on Jan 04, 2013

Tribute all sudden overheat on a cold night

Driving on freeway once hit 50 mph temp guage shot up to red zone. would sit for a awhile but once again less than a mile down the road it started to overgeat.

  • Anonymous Jan 09, 2013

    turns out the belt tensioner snapped off. so that was replace along with the serpetine belt. now the engine light stays on? hoping its not a major repair ahead of me. suggestions?

×

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Master 2,101 Answers
  • Posted on Jan 04, 2013
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Oct 23, 2012
Answers
2101
Questions
1
Helped
582425
Points
6613

What motor do you have? check all the hoses see to see if any are leaking and see if the coolant level is full. may have a stuck thermostat

  • 1 more comment 
  • Anonymous Jan 09, 2013

    turns out the belt tensioner snapped off. so that was replace along with the serpetine belt. now the engine light stays on? hoping its not a major repair ahead of me. suggestions?

  • Anonymous Jan 09, 2013

    any parts store will scan it for free,and I need the codes that are coming up

  • Anonymous Jan 10, 2013

    code is P1299 we add coolant. the guy said the engine should reset after driving 50 miles. i havent really driiven the car due to the engine light b on. the temp guage will go right into middle of the guage. the clerk said that should not be happening due to the cool weather we are having. i drove on the freeway and the temp guage did not move. hoowever i was scared it overheat again. so i may only driven 3 miles on the highway. thoughts?

×

3 Related Answers

Anonymous

  • 1 Answer
  • Posted on Feb 10, 2009

SOURCE: My mazda mvp van keeps

try replacing the fule filter and useing gas treatment to clean up injecters. also get a tuneup.i have had simaler probs with mine and have had success with these steps.

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 29, 2009

SOURCE: Mazda Tribute 2002 engine cuts out randomly

I had a Mazda 626 with a similar problem, the car seemed to 'shut down' with no warning, even at highway speeds, as if I just turned the ignition key to 'Off'; After trying to fix it unsuccessfully by replacing several electrical parts, the problem was found to be a defective ignition switch, it was replaced and the problem went away.

Adrian Walker

  • 26 Answers
  • Posted on Sep 01, 2009

SOURCE: High Revs when in Neutral and must moving w/Temp guage out

Tributes are built by ford in Missouri...just fyi

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 2005 Mazda tribute and while driving the transmission shifts from drive to 1st, then 2nd, then drive and it will do this off and on the entire time I am driving. The fluid looks clean.

Mazda Tribute Transmission Problems - Edmunds.com

forums.edmunds.com > Mazda > Mazda Tribute

Dec 6, 2007 - 31 posts - ‎20 authors
In March 2005 I purchased my brand new Mazda Tribute. ... When the transmissionproblems first started I explained to Mazda that I .... The whole four wheel drive! ...While they were driving on the freeway, the engine revved a little. ... When it isshifting into or out of overdrive around 50 mph sometimes the ... Mercury Mariner Transmission Problems
31 posts
Apr 5, 2007
Nissan Quest Transmission Problems
31 posts
Nov 7, 2006
Mazda Tribute Gear Selector
15 posts
Aug 2, 2006
More results from forums.edmunds.com

2004 Mazda Tribute / Ford Escape Transmission trouble ...



0helpful
1answer

Temp.guage on instrament panel is erradic

Could be the temp sensor or the gauge on the dash is faulty.
Does the gauge go to cold if you disconnect the sensor ?
1helpful
1answer

Why is mybcm not letting me pass insp there is no code on thi1996 chry lhs what is going on

You mean PCM most states read the readiness monitors depending on the state on how many they allow not to be completed. The first one on the list that is hard to get run and pass is the EVAP Because this requires the car to be cold and fuel tank must between 15%-85% and both air temp and coolant temp with in 10 degrees of each other. Start car let idle for 5 -10 minutes Then drive car normally no hard accelerations or quick stops bring speed to 50-60 mph and coast down to 20-15 mph without brake pedal input repeat this twice.Then bring speed to 58-62 mph and set cruise control run for 12-16 miles exit freeway caught a red light or stop and idle 2 minutes shut car off rest for 5 minutes and repeat freeway drive. then redo morning cold start again . then have some one test the generic readiness monitors to what needs to run and attempt again. California before 2000 1 can be incomplete after 2000 all have to be completed which is hard some will not run for 800 miles.
0helpful
1answer

Over heating

check and see if the fan is working and check the fan relay
2helpful
1answer
0helpful
1answer

My 1992 lexus es 300 overheats after i get off the freeway. the temp gauge sits in the normal position until i get off the freeway. i run the heat on hot and at full blast regardless of the temp outside...

Sounds like you could be low on coolant, even more so because the air starts to cool down, check coolant level with engine cold, never open a radiator when hot.
5helpful
3answers

Would the heater control valve malfunctioning make the engine overheat blowing hot air out the heater one moment,then not blowing the hot air, temp gage spikes 225 plus. The motor takes awhile to heat up...

Heater control valve malfunction will not cause engine to overheat unless coolant is leaking externally...Overheating going down the road can be the result of a few different things...Partly clogged radiator...Insufficient air flow due to possible fan problem...External coolant leak...Make sure fans are operting properly and have cooling system pressure tested for leaks...Gaining and losing heat on the inside of the vehicle usually means system is low on coolant but you must find out where coolant is going
0helpful
1answer

2004 Chevy Venture overheats

check the make sure you have no air in your system if there is an air bubble trapped in behind the thermostat your thermostat wont open and your car will heat up and stay hot while letting a small amount of coolant through the bypass so it wont overheat
0helpful
1answer

Temp guage runs in the red! 93 mark VIII 135K miles

has the water pump been changed recently? The water pump on a 4.6L 2v and 4.6L 4v look the same but are different
Not finding what you are looking for?

164 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...