Try this please!
'98 - '02 Isuzu Rodeo and Trooper and Honda Passport(with factory keyless entry) Instructions for programming.
1. Get in car and make sure all doors are unlocked.
2. Open driver's door and leave open.
3. Put key in ignition.
4. Turn key to 'on position' (dash lights on, but do not start) and back to 'off position' 3 times in 5 seconds or less. (you must turn the key very fast)
5. Close and open driver's door 2 times in 5 seconds or less.
6. Turn key to 'on position' and back to 'off position' 5 times in 5 seconds or less. (turn key very fast)
7. Close and open driver's door the doors should lock and unlock twice after this happens push the lock or unlock button on the remote, doors will lock and unlock. Push the lock or unlock button a second time and doors will lock and unlock again. You are finished! The above sequence erases all previous codes and adds the new code as #1. If you are adding a second remote, you should follow the same sequence with the exception of step 6; instead of turning the key to the 'on position' and back to the 'off position' 5 times in 5 seconds or less, do it 3 times in 5 seconds or less and then continue to step 7. ***Remember to turn the key to the on and off position very fast.
This works! Follow directions EXACTLY. I had to try 3-4 times before getting it to work. I failed to go exactly by the instructions the first few times.
SOURCE: 2000 Honda Passport wont start.
I ended up finding a repair shop here in Cleveland. The problem ended up being a short in the electrical system. My fuse kept blowing. That's why it wouldn't restart. If you decide to take your vehicle to a repair shop, have them check out the electrical system. My problem was found under the drivers side fender. Some of the wires were corroded. Good luck!
SOURCE: where is throttle position sensor located on 2000 honda passport
Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.
SOURCE: Vacuum Leak on a 2000 Honda passport
Replace upper intake gaskets. They are made of metal and plastic. A common problem. Do not remove the very top plenum cover gasket.
SOURCE: diagram for serpitine belt honda passport 2000
There should be a diagram on the front rail ..where you hood latches....unless someone has removed it...if it has been removed ..i'll try to find the diagram for it...i hope this helps...Keith
478 views
Usually answered in minutes!
×