At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There have to be something you missed during your troubleshoot. If the switch to turn on the a/c is good, since it turns on the a/c compressor, then it must be a wire that it's not connecting, or (not sure if there is any in these vehicle) a sensor, which controls the speed of the a/c blower. I'm sharing this because I took apart my vehicle's a/c blower motor, and right at the firewall, there was a sensor. If that is damage, then the blower won't work.
check fuses if they are still good change the blower motor instructions below not hard to do!
Disconnect the negative battery cable.
Disconnect the blower motor lead connector from the wiring harness connector.
Remove the blower motor cooling tube from the blower motor.
Remove the four retaining screws.
Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
Lift up on the blower and remove it from the blower housing.
Installation the new blower motor by reversing the removal steps.
if you haven't got your blower fan fixed yet, im sure it to be the same as mine, the blower motor relay which is out on the firewall under the big fuse block. take plastic cover off over the fuses and move the fuse block out of the way and you will see it staight under that. should be two screws holding it on.
I would check the fuses to be sure no issue there, then... I would check the blower resistors next. This should be a module very near or mounted to the blower motor.
There is a fusible link for the blower motor. Check that. Don't know where it is. Look up the wiring diagram at autozone.com. Also check the fuse in the fuse box. Could just be that.
×