Abs light on as well as brack light on the das

They should reset themselves or "go off" by themselves. Its possible you have instead a short or broken wire that was giving you a false indication in the first place

hi i would check the abs module its located on the abs pump it controls the speedometer and can also bring lights on the dash eg abs &the brake warning light

My 2003 Monte Carlo and my husbands 2003 chevy pickup both had the ABS and traction control lights on. When it began it only came on once in a while but got worse until the lights were on all the time. After several attempts to find the problem we purchased a ABS Brack Scan. Part #CP9449. Although it doesn't pinpoint the exact problem it does tell you what wheel has the issue and possible problems. My problem was a bad wire in the harness. Good luck!

this means that one of you abs wheel sensors is not working take voltmeter check each wheel senser there on the caliper around it should be 12 volts then check fluid cause brake fluid set off brake light too but those only two possibilitys

The accident caused a possible short circuit in the circuit and wires serving the ABS ,Engind and hand brake light system best to get checked by a Auto Electrician

Bleed the breaks.

Be aware that if the (BRAKE!) light is on you are probably low on brake fluid and while your brakes are still working properly, there is a possible fluid leak somewhere that is going to causse them to not work at all. When this light is on it is serious. Although the sensor in the master cylinder that tells this light to come on is probably the answer, as they tend to malfunction in your vehicle. Check your brake fluid immediately, and fill it if it is legitimately low.
If the (ABS) brake light is on it is probably an ABS speed sensor in the vehicle that is bad, If the abs light is on have a service center do a diagnostic scan to verify which sensor is bad.

Just a thought ....... check for uneven tire pressure , or different tire sizes.

It is the same as the older cars.
Just change the pads as usual.
It`s when you come to bleed the brakes that problems arise.

im pretty sure its your fluid level (steering) screw top as you stand infront of car right hand side screw top with metal connector attached