SOURCE: 1994 jeep wrangler reaer differential oil
It should be just 80/90 gear lube unless ya got a locking diff but most just take 80/90
SOURCE: how do I bleed hydraulic clutch in 1991 jeep
There is a bleeder on the drivers side of the transmission follow the tube from the clutch master cylinder if you cannot find it. Pump the clutch up and hold it down then open the bleeder repeat till air is gone. May have to bleed again after driving a bit. If you want to bleed the clutch master cylinder run a tube from where the line goes into the cylinder and take the cap off and run the tube into the fluid (make sure its in the fluid) then pump the clutch slowly until no air bubbles. I just replaced my clutch master cylinder this is where the information comes from hope it helps you out!
SOURCE: 1991 jeep wrangler clutch
U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.
SOURCE: 1991 jeep wrangler: alternator overcharging
It sounds as the voltage regulator which is built into the back of the alternator has stuck. Occaisionally this even happens on new ones. Would suggest taking the alternator back as it shoud be under warranty.
SOURCE: where is the clutch resevoir for a 94 jeep wrangler yj
if it is on the firewall then yes it is the clutch fluid resovior.
51 views
Usually answered in minutes!
×