How do i remove inside door panel off a suzuki vitara

SOURCE: How do I remove the

I have a suzuki esteem 2000 and to remove the inside of the door panel you must first locate the window roll down lever and when you push back on the panel it opeans up a gap between the lever and the panel and if you look there is an axile that connects to the lever and in the lever there is a set of groovs and if you look at the groves there is a snap on ring, you must first push that ring off of the axile which will let you to freelly pull the lever off and then you can locate the screws that also hold the panel on my suzuki I have one on the handle which is covered by a plastic cap and there is also another palstic cap a little lower. After you have freed the screws the rest are just snap on clips you can just pull the panel off.

well hope it was helpfull.

SOURCE: speaker removal instructions for 2002 grand vitara

You need to take to whole front door trims off, the rear speaker grills just pop off.

SOURCE: how i remove the door panels from a suzuki grand

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

SOURCE: change rear brake pads on Suzuki Grand Vitara 2001

you will see a hole which is theaded on drum, slacken hand break cable, then screw a bolt into the hole, this will push off drum, dont no what size bolt is, you can buy a selection cheap at b.q

SOURCE: door panel removal

To remove the window crank slip a small standard screwdriver behind where the crank mounts to the door.There is a small spring like c-clip pop the clip off and cran Window Handle Operation:
Replacement handle for cranking or rolling a side or rear window up or down. It slides over the window crankshaft and uses splines to match the window crank shaft splines as to avoid slippage. It's held in place with a simple spring clip and come in a variety of styles and colors.k will come off.