Replacing the front indicator lenses for clear ones?

Sounds like you may have blown a fuse. Good luck

According with the 1991-1999-BMW-e36-318i-318is-323i-323is-328i-328is Owners Manual...




Hope this helps (remember to rate this answer).

ive had the same problem on my 1998 Bmw 323i when i took my battery cable off what you have to do is leave your key in the ignition position 1 so the radio is on and says code wait. you have to leave the key in the ignition in that position for about 30- 1 hour long then it should reset back to where you enter your radio code. you only have about 3 trys to get the code right then it will say code wait again. you need to find out what your radio code is. my radio code was 46661 but we could have different radios. you can either bring your car to the dealer or just take out your radio and get the serieal number off of it which is what i did and i typed bmw radio code in online hope this helps !!

check cam Positioning sensors

ive heard people say that on a auto transmission on a BMW that if it wont go into reverse there might be something wrong with the transmission... just a thought, i might be wrong

Hi,   the lever that you use to opperate the indicators,  has it got a little press button on the end of it,

1. Lever out retaining clip from top and pull turn-indicator light forwards. 2. Unlock and take off bulb holder. 3. Turn and pull out bulb.

put your right signal on walk round your car you may find that 1 of your bulbs is out

When you open your hood there is a hole in the fender you need to stick a small and long skrewdriver in it and push the clip down and pull the light out with your other hand

-switch off ignition

-press the daily miles button and keep it pressed for the next two steps below

-switch on ignition (dont start)

-wait for display to show "reset"

-let go the daily miles button and press it once again

Good luck..