1993 Volvo 940 Logo

Related Topics:

Victor Posted on Dec 30, 2012

Reset check engine light for Volvo 1993 940

I have 1993 Volvo 940 turbo . The check engine light just true on The car rpm will not stay 1 mark. Wen I put the car in d . Car will not . Rpm will not stay at the 1 mark.

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Jul 28, 2008

SOURCE: Engine management light

my car volvo s40 2000 had problem with engine managment light. I took it to the garage & they did dignostic check and the problem was(reset the camshaft valve)he gave me the part nomber and i put new part in ad problem solved.i do not know the name of part but this part is next to the spark plugs on right hand side,its got 4 bullts and the wire pluged in to it. It might be not problem with your car becaus macanic told me that this is not the common foult with s40, with yor car it may be sensor. good luck

Ad

Anonymous

  • 1 Answer
  • Posted on Nov 03, 2008

SOURCE: engine management light volvo s40 problem

The best thing is to go to your local Volvo maintenance shop or Volvo experts to find out whats the problem..usually the coomon ones I think is the programs inside its ECU unit..you try this..ask the volvo experts to reset the ECU and lets see..if problem arise then it is no doubt you might need the sensor..hope this help..

Anonymous

  • 4 Answers
  • Posted on Dec 19, 2008

SOURCE: 76 volvo 240 car idles and low speed is rough,

It could be the filter. Has the fuel been changed after storage? I would also thing the Carburetor or the fuel injectors might need to be cleaned.

onyeredson

Paul W

  • 404 Answers
  • Posted on Jan 05, 2009

SOURCE: car will start but won't stay running

Hi!
I'm presuming the B23 engine? Have you checked fuel pressure valve located on the inlet manifold, are your plugs getting soaked in fuel?
If not try looking at the Fuel relay in the block situated behind the ash tray below the Radio.
It might be easier for you to access this by taking out the coin tray, flip the cover plate off the cigar lighter it will reveal 2 screws, take that out and the tray then you'll see a whole lot more relays.
There are different types/colours I'm guessing your could be Blue but there are white ones too.Try Jiggling them carefully then crank the engine if it runs but poorly replace.
You must replace with correct one even if it is Blue some have Copper Lugs others steel and they are different.
Good Luck!
Paul 'W'

Anonymous

  • 1 Answer
  • Posted on May 18, 2009

SOURCE: reset check and service engine lights

It's in the console under the coin holder, in front of the gear shifter. You have to remove the coin holder and you will see it.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My s60 2,5t wont stay start when shift in gear can anyone help me please

NO YEAR CAR told is it a car ?
NO car maker told, wow, a toyoto or Volvo ?

google has zillion hits for Volvo .so lets with that.
ahhh 2.4 t is (turbo engine)single or twin?
made 2000 to 2018, S60, s60R and S60L and more.

guessing it:

2497 cc B5254T12 turbo I5 (1 turbo right not the twin,)
why make me guess YEAR and get exact engine correct
or
2400 cc D5244T10/T11/T15 twin-turbo I5
Engine is Dead, , starts/ and stalls' so both keys do that?
the IMMO lamp glows wrong and key is bad? "security lamp"

I can not decode "won't stay start, when shift gear."
yes I get the idea of stalls yes.
does that mean it does start OKAY and idles all day if just doing that."? in park?
or idles all day but shifting to PRNDL, drive , REVERSE or LOW
the engine stalls in any gear well that can be many things.
I that means engine power is super low, (as in pathetic)
1:Low fuel pressure (use a pressure meter to check it)
2: scan tool shows bad MAF OR MAP sensors.
3: spark plugs10 years old?
4: idle controls dead, IAC/ISC.

check all fuses
and scan the PCM, and for sure at idle if it does in PARK.
can I assume transmission is auto not manual shifted?
3helpful
1answer

What should the timing setting be at on a Volvo 740

For a 1990 Volvo 2.3 SOHC B230 at 700-800 rpm 12 degrees
at 2500 rpm 21 degrees plus or minus 1 degree

For a 1990 Volvo 2.3 DOHC 15 dergrees BTDC

For a 1990 Volvo SOHC turbo same as SOHC specs
1helpful
1answer

Use 1st turbo n 1st gear then change nd theaz no boost tl 2nd turbo 2nd gear no power.check engine light cums on wen start the car and turbo timer dosnt work

CODE SCAN VECHICLE TO SEE WHAT CAUSING CHECK ENGINE LIGHT TO COME ON.SOUND LIKE TURBOCHARGER REGULATATING VALVE AND ECM PROBLEMS.
2helpful
3answers

Can i replace a volvo s40 turbo engine with a regular non turbo volvo s40 engine. my mechanic says he can install the turbo from the toasted turbo engine on the non turbo engine but that he will have to...

tHIS WILL TURN ON AND KEEP THE CHECK ENGINE LIGHT ON, MOST OF THE ENGINE BLOCKS ARE THE SAME BUT ARE BUILT A LITTLE STRONGER TO WITHSTAND THE TURBO, IF HE CONNECTS THE TURBO AND YOU DONT BEAT ON THE MOTOR I THINH YOU WILL BE OKAY, HAVE HIM USE ALL THE OLD PARTS LIKE INTAKE INJECTORS OIL PAN EXHAUST MANIFOLD AND I THINK IT WILL BE FINE, HOPE THIS IS HELPFUL,
0helpful
1answer

Ignition timing specs for a 1988 volvo 760 turbo wagon ?

It is most likely going to be between 5 and 15 degrees BTDC. I would put it at 5 degrees BTDC. At idle, if the motor is extremely quiet, but the exhaust loud, move it to 10. As you advance the timing, the motor should become louder and the exhaust quieter (at idle). As you increase RPMs, the motor should get quieter and the exhaust louder. This is only true with an injector pump that has static timing (does not automatically increase with increased RPM).
If your engine has dynamic timing (automatically advances with increased RPM), then I would set the timing at 5 degrees, test run. Maybe change to 7 degrees, test run...etc. Basically, don't make dramatic changes with the injector pump timing if it is dynamic. I hope this helps.
2helpful
1answer

Wen I push it a little more then normaly, de yelow motorlamp goes on. ist happand on about 150 km/h. and 3000 rpm.

If the light goes on and keeps flashing, then it's detecting a misfire in your engine. If the light goes on and stays solid, then it could be anything. If you take your car to a place like Autozone(free) and have it scanned, they'll be able to retrieve the codes that will narrow down what the issue is
0helpful
1answer

91 volvo stalls at anytime

TRY ANOTHER FUEL PUMP AND FUEL FILTHER THESE PUMPS ARE FUNNY ON VOLVOS HAD SAME PROBLEM ON 850 TURBO AND SURE ENOUGG IT WAS THE PUMP
1helpful
2answers

Volvo 940 GL 1995 Soft Turbo

First check for holes or disconnected air inlet hoses, that will give the sensor/meter a problem so it cannot send the correct signal.
1helpful
1answer

Check engine codes

1-2-3* Signal missing to/from coolant temp. sensor Wiring fault to or in ECT sensor;grounds corroded on intake manifold or engine Difficult to start engine when cold Same Same
Not finding what you are looking for?

283 views

Ask a Question

Usually answered in minutes!

Top Volvo Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...