2001 Toyota Echo Logo

Related Topics:

A
Anonymous Posted on Dec 29, 2012
Be the first to answer

Changing front driver side turn indicator light

Need to change turn indicator bulb

Answer This Question

5 Related Answers

Anonymous

  • 10865 Answers
  • Posted on Feb 16, 2009

SOURCE: Need to change the front side marker bulbs

Do not attempt to remove the housing. Attack from the underside. Turn the wheel so that it points out. Pull back the thin black covering in the wheelwell part way. This is done by starting at the front of the car and part way up the wheelwell. You will need to remove two screws and one black snap button. (If the button breaks, you can get them at the dealership for pennies.) You should now have access to the bulb socket. Entire process should take approximately 10 minutes.

please rate my answer as a fixya!

Ad

Anonymous

  • 1 Answer
  • Posted on May 24, 2009

SOURCE: Remove and Replace Turn Indicator Bulb

Resolved! I finally just put the bulb in the palm of my hand and put my fingers on the plastic socket (which I had given the quarter turn to release from the housing) and gave it some good firm pressure and it snapped/locked into place.

Vitally Alcher

  • 1645 Answers
  • Posted on Jun 02, 2009

SOURCE: 2001 Toyota Tacoma- turn lights not working and cruise control

fuses???
Check relays.....
Harness grounds, engine ground,
Check the trailer harnes for short.
Vitally

c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Jun 25, 2009

SOURCE: how do you change a front side light bulb

Turn Signal/Marker Light REMOVAL & INSTALLATION

  1. Remove the one retaining screw from the upper corner of the lens.
  2. Tape the end of a pry tool, then carefully extract from the bottom of the lens in a rocking motion till the stud is loosened from the retainer.
  3. NOTE: Do not pry from the back of the lens, this will crack the lens or damage the paint.
  4. Pull the lens assembly straight out from the body towards the front of the vehicle.
  5. Twist and remove the wiring from the back of the lens.
  6. Twist the bulb and remove it from the socket.
Fig. 5: Once the bulb is removed, inspect the socket for corrosion 90916p10.jpg
To install:
  • Before installing a light bulb into the socket, ensure that all electrical contact surfaces are free of corrosion or dirt. NOTE: Before installing the light bulb, note the positions of the two retaining pins on the bulb. They will likely be at different heights on the bulb, to ensure that the bulb is installed correctly. If, when installing the bulb, it does not turn easily, do not force it. Remove the bulb and rotate it 180 degrees from its former position, then reinsert it into the bulb socket.
  • Insert the light bulb into the socket and, while depressing the bulb, twist it 1/8 turn clockwise until the two pins on the light bulb are properly engaged in the socket.
  • To ensure that the replacement bulb functions properly, activate the applicable switch to illuminate the bulb which was just replaced. If the replacement light bulb does not illuminate, either it too is faulty or there is a problem in the bulb circuit or switch. Correct if necessary.
  • Install the socket and bulb assembly into the rear of the lens housing; otherwise, install the lens over the bulb.
  • Insert and secure the lens assembly into the body of the vehicle.

    • Anonymous

    • 1 Answer
    • Posted on Jan 03, 2010

    SOURCE: change front side light fo0r toyota hice van

    how to replace sidelight cover on th driver side of toyota 2002 ce?

    Ad

    Add Your Answer

    ×

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    0helpful
    3answers

    My marker lights work but when I use the turn signal the passenger side wont blink I checked the fuses they're good
    Change the bulb, as a matter of fact they're probably both the same age so change both sides. I hope this helps. Take care.
    Read full answer
    Apr 08, 2019 • Cars & Trucks
    0helpful
    2answers

    2002 Siverado left front turn signal luminating when lights are in use but will not flash when turn signal activated. Rear signal flashes quickly and dash indicator as well.
    You need to change the bulb in the Left front lamp. I hope this helps. Take care.
    Read full answer
    Mar 28, 2019 • Chevrolet Silverado Cars & Trucks
    1helpful
    2answers

    2007 Uplander. The tail lights on the driver side will not come on, but they are working on the passenger side and the front. The brake light and turn signal work on the problem side and all the other...
    GM doesn't have the best tail light setup. do you own a test light? You should start at the back. The turn signals and hazards use one bulb. The brake light uses another bulb. Remove the bulb and carefully test for ground and power. If it is there then it is either the bulb or related contacts. If power or ground is not there then unplug the tail light assemble and test for power or ground again. The tail light circuit board is notorious for going bad. Please start here and write back if you need further help.
    Read full answer
    Oct 29, 2018 • Cars & Trucks
    0helpful
    1answer

    Drivers side rear indicator flashing fast, was told it was a faulty bulb , have changed the bulb , but still doing doing this ?
    If your talking about turn signal, does the front driver side turn signal work ok?
    Read full answer
    Sep 30, 2016 • 2005 Ford Focus
    0helpful
    2answers

    Drivers side turn signal blinking fast other side normal, bulb change didn't help
    Even after bulb change, do all lamps work? Bad ground can be shown by weak or dim bulb sometimes and this can cause fast flashing. All bulbs which flash must be working and of normal brightness which is sometimes hard to tell when they blink really fast.
    Read full answer
    Feb 27, 2015 • 2006 Lincoln Town Car
    0helpful
    1answer

    HOW DO YOU CHANGE FRONT INDICATOR BULB THANK YOU
    If I remember there's an access panel in wheel arch cover you have to turn wheel inward on which side it on
    Read full answer
    May 05, 2014 • 2003 Renault Kangoo
    0helpful
    1answer

    Front driver's side signal light does not work. Changed the bulb and it still does not work. The driver's side rear works and the passenger side works (front and back). Also, when the signal arm is pushed...
    when a bulb fails on one side of the indicators the other bulb, same side, flashes faster, SO.you have just answered the question yourself,as you have replaced the bulb with a new one, the contacts for the new bulb are at fault.
    Read full answer
    Sep 11, 2010 • Hummer H3 Cars & Trucks
    0helpful
    1answer

    Driver front turn signal does not blink. front
    This may have more then one bulb in the front or possibly a bad socket try wiggling the new bulb in the socket to see if it will work.Compare all turn signal lights that come on the passenger side to those drivers side.Some vehicles also incorporate sidemarker lights with the turn signals.
    Read full answer
    May 29, 2010 • 2001 Pontiac Aztek
    2helpful
    2answers

    "Failed RH Indicator"
    Check your right hand indicator bulbs, front and rear.
    Simply a case of changing a blown light bulb.
    Read full answer
    Sep 17, 2009 • 2001 Jaguar S-Type
    0helpful
    1answer

    Problem with driver side indicator light
    Fast flashing is a warning that one of the bulbs is not working. if the front flasher d/side is out try changing the bulb and cleaning the terminals inside the unit.
    Read full answer
    Jul 29, 2009 • 2006 Ford Focus
    Not finding what you are looking for?

    View Most Popular

    2001 Echo

    • Cars & Trucks

    Related Question

    My marker lights work but when I use the turn signal the passenger side wont blink I checked the fuses they're good

    • Cars & Trucks

    209 views

    Ask a Question

    Usually answered in minutes!

    Popular Questions

    Have codes P0441, P0442, and P0446. What could be

    2003 Toyota ECHO

    How do you fix an Igniter Circuit Malfunction -

    2002 Toyota ECHO

    P1300,p 1305,p1310,p1315 how do i fix these fault codes on a Toyota echo 2005.

    2005 Toyota ECHO

    Toyota ECHO REAR DOOR HANDLE problem

    2001 Toyota Echo

    Location of fuel filter on toyota echo 2000.Is

    2000 Toyota ECHO

    Check Out the Latest Top Trucks Report!
    Check Out the Latest Top Trucks Report!

    View all Fixya Reports

    Top Toyota Experts

    ZJ Limited
    ZJ Limited

    Level 3 Expert

    17989 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    15088 Answers

    ROBERT GARCIA
    ROBERT GARCIA

    Level 3 Expert

    926 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...