2000 Buick Regal wont unlock with key or remote key fob.

Windows rolling up and down by themselves and ABS, ESP/BAS, and TC ...

www.challengerforumz.com/.../windows-rolling-up-and-down-by-thems...

Nov 13, 2012 - The top part of the window goes up and down after i shut the cardown. ... To not have this happen until my appt at the dealer, i rolled the window down a crack so it wont go up and down. ... cracking just enough to let wind in, then if i have to fight it for 2 min, before it finally stays up. .... Joined: Aug 23, 2009. Dodge Challenger Electrical Problems and Questions ' Dodge ...
Apr 30, 2015
Auto Window's Down Function
Jun 20, 2013
Car unlocks by itself
Jul 8, 2010
Smart Window Recalibration Issue?
May 20, 2009
More results from www.challengerforumz.com

Cable Failure in Window Regulator/Motor May Cause ...

repairpal.com > Problems > Dodge > Charger

Dodge Charger Cable Failure in Window Regulator/Motor May Cause Power Windowsto Become Inoperative. This is a verified ... 2009 Dodge Charger128,000Visitor ... Thewindow rolls down but wont go up except when driver door is open.

How to instantly lower your car windows with the key remote ...

www.cnet.com > Security

CNETAug 30, 2012 - How to instantly lower your car windows with the key remote ... Dodge (Challenger/Charger/Durango/Grand Caravan/Journey/Ram); Fiat (Bravo) ... that's how the windows rolled down because I know I didn't roll them down is this a ... Honda Accord 2009 V6, American assembly -the feature works perfectly ...

Dodge Challenger Re-Calibration windows trick - YouTube

? 5:00
https://www.youtube.com/watch?v=zRLzN61GaS4

probably the FOB, just because other functions work does not mean that the lock/unlock will work. This is the most used function and the one that goes first.

My remote would not work for any function. Took it appart and cleaned the circut board with alcohol and now everything works.

sounds like the hard wire attached to the key lock may be off or broken..this happens a lot when a car is "slim jimmed" or used a coat hanger to unlock the door.. or it could be from just normal wear.. the door panel will have to come off the door to be able to look inside and see what is happening.. simple, inexpensive fix for someone with a little mechanical ability

I had same problem. Driver door would lock/unlock with key in keyhole in door, but not with fob, and other doors would not lock/unlock. Even once inside none of the doors would lock/unlock with lock switch, or even by pulling handles. Mechanic (very trustworthy) explained I needed a new control module (cost me $600). Good Luck. $600 is better than having to roll down the windows so Grandma can Luke Duke it outta the car.

THE PROBLEM SOUNDS LIKE LOOSE WIRING CONECTIONS IN THE DRIVERS DOOR , BEST THING TO DO IS HAVE A LOOK OPEN UP DOOR PANEL AND CHECK ALL CONECTIONS, GOOD LUCK

I had that happen too and found out that if you hold the unlock button down on your FOB for about 4-5 seconds then it will roll down the front windows. It's actually a feature, not a problem. You may have accidentally mashed something up against the FOB while it was in your pocket and you were within range of the car. That's what I did. Freaked me out the first time I walked out in the driveway and both front windows were down and I know I didn't leave them open.

contacts in window motors sometimes get dirty from lack of use. Take a rubber hammer and beat under the interior edge of the open door while working the switch (don't be gentle). It it works, exercise the window more frequently.

You need a body control computer, which controls the windows, door locks and other items. The new computer will have to be programed by a good imports shop or Nissan dealer.

make sure than you have not split any fluids on the passenger front door most of the times is where the module to control the windows and doors is located, try by unpluging the batterie and the after a minute plug it back and see what happend but if any of your ft doors have been split with liquid or rain has gone inside then most likelly the module got moisture and not working