I am tryng to remove a factory Honda radio in a 1991 Honda Accord LX 5 speed.
Can any one tell me how to remove the bezel around the radio or any schmatics would be very helpful.
Start by removing the console. there should be four screws that hold it in; two on each side; one in the front and one in the rear. you may have to take the gearshift knob of if the car is manual trans.then, remove the ash tray. there are two screws at the front of the ashtray receiver and one at the back.with the ashtray and slide removed, take the bezel off of the radio. there should be two screws behind or above the air outlet vents on top andn two screws in the under the center dividing rail. you may have to pop out the air outlets to get to the screws. there may also be a screw at the bottom of the bezel in the center.with the bezel removed the only thing that holds the radio in at that point is two screws that come up from underneath where the ashtray receiver was. take out those two screws and the radio should pull out from the front. Be sure to disconnect the antenna lead and the connector from the back of the radio before pulling on it too hard or you'll damage one or the other.hope that helps
995 views
Usually answered in minutes!
Thank you MNfisherman I;ll give it a try. One question, do I still need to remove the center counsol with it being a standard transmission?
recalls for a 2002 honda accord lx
i have a code 8 on a 92 honda accord lx what does it mean
Honda Accord 2.0i 1991
×