My drivers seat wont move.

It sounds like the motor for the forward/backward motion is out. Or the switch is bad.

you may have just over run the end stop , try sitting in seat and whilst pressing the back button push with your feet against the floor , this might get the seat moving again , if not i think you may be looking at getting a new switch , but get it checked by a mechanic first as there may be some other way to get it moving

could be. could be a switch or motor. different switch contacts for up/down along with different motor

check fuse.if fuse is good check for power at seat motor.if yes replace seat motor.if no check wires at switch.if wires is not loose or broken seat motor switch could be bad.

Check the fuse box for a blown fuse, both seats may operate on one fuse depending on the model of vehicle and the fuse may be located either under the dash on the drivers side or in the engine compartment on the drivers side.

You can move the drivers seat back by turning on the power, getting in the seat and position your feet firmly on the fron flor with your back firmly against he seatback, and then engage the switch pushing back - while pushing like hell with your feet. You can actually hear the seat drive shaft turning while the seat moves back. The principle should be the same for moving forward, but pressure would have to be aplide to the back of the seat.

is look like a fuse blowen you need to replace it look in the munual book

if thare is a clicking sound heard then the fuse is not blown so this means ether the seat motor or transmission has gone bad and you half to replace the hole seat track, cause i dont think servisable parts are available for this vehicle

I'm assuming this is a power seat. If so, there are separate motors that control the various functions of the seat such as forward/backard, recline, lumbar support, etc. It could be that the motor or an electrical connection to the motor for the forward/backward motion is faulty. Normally all of the motors would be on the same power circuit, so if some of the functions are working then it is probably not a blown fuse.

Just one other personal observation, I have actually seen an instance where some loose pocket change had spilled under the seat and a quarter had become wedged in the track that the seat slides in and had jammed the tracks so tightly that the seat would not move.

One thing to note is whether or not you hear anything when you try to move the seat forward/backward. If you hear a click or a buzz when you press the button then that could mean that something is physically jamming the seat tracks. If you don't hear anything when you press the button, then that more than likely means a problem with the motor or the electrical connection to the motor.

Good day;
What year is you car? Does the other controls work for the seat? and just to clarify the seat won't go forward of back?


Cheers