Tried replacing cable from firewall in car-disembled the console,removed the cable T from shifter under the hood removed the shifter flang to the xmission-disconnected the cable jig...everythings disconnected but the cable will not come out thru the outside or in...cable goes thru a plastic duct under carpet
SOURCE: plastic pieces on shifter handle
no the the whole piece that the overdrive button goes into on the shifter . Its black at the very end of shifter. you know the shifter is metal,and the piece is at the end of that.
SOURCE: air bag light 2001 ford focus
the computer probably just needs reset because the seat belt warning feedback is tied in to airbag system. try disconnecting the neg battery terminal for about 5 min
SOURCE: INSIDE HOOD RELEASE ..NOT OPENING HOOD LATCH
stretched or frozen... have helper bang on hood center front while you tug..once open lube abd grease all latch areas and cable end you see there...good luck
SOURCE: I have a 1995 Ford Taurus SHO 3.0 liters. I
Hi did you do a continuity check check if there's a wire shorted or open you'll need a volt meter check if the wires on the crank sensor going to the control module and also the one from the coil to the module there has to be a shorted or open wire check this and get back to me good luck
SOURCE: 2001 FORD FOCUS SHIFTER CABLE SNAPED
You did not need to remove the heater box to replace the cable. There is a hole in the floor the cable passes through.
228 views
Usually answered in minutes!
×