SOURCE: engine diagram showing location of
Hello cmalstrom.
The sensor is mounted to the right of the harmonic balancer at the front of the engine.
On the diagram below look to the left about 3/4 of the way down.
I apologize for the size, we are limited here for amount of room.
If you need more help with this please ask me.
Thank you for using FixYa.
KL
SOURCE: I need the location of the low pressure ac port
The lincoln better idea engineers put the low side freon port in a peculiar place.. You will find the low pressure port near the compressor under the car on the driver's side. You will need to put your car on a lift to get to it. Once you raise your vehicle, take the plastic shields off and you will find the compressor...yup...it's a tight spot.
Hope i was able to answer your question...be safe.
SOURCE: 2002 LS: aHow do I fill radiator in my V8 Lincoln LS...
First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)
SOURCE: diagram for a 2000 lincoln ls V8
Your best ,to cut the old belt,to remove.
You can use a long handle 1/2" drive ratchet, on the belt tensioner.
The only pic is in the shop manual.
Wear long sleeves and arm protector sleeves on top. the fan housing is sharp and a tight fit. You will be there a couple hours.
Draw a picture before you start, and you won't need a diagram
SOURCE: Location: Coolant Temp Sensor 2001 Lincoln LS V6
It is on the Driver side of engine in between the COP's (Coil on plugs) simply unplug the wire use a 19 or 3/4 deep well socket and unscrew it and put it new one... The whole process should only take 10-15 minutes.
1,086 views
Usually answered in minutes!
×