96 CHEVY CAVALIER. R&R DRIVE AXLE SHAFTS. AUTO TRANS.

yes actually 95 to 05 1995-2005 Chevrolet Cavalier CV Axle Assembly, Chevrolet Cavalier Drive Axles, API CV Axle Assembly, API Drive Axles SKU: API 1700197008, API 3158-07726494 CV Axle Assembly -- Pass. Side Axle Has Stub Shaft Inserted Into The Splines Of The Inboard Joint; If stub shaft stays on axle upon removal you must transfer to the replacement unit. Driveshaft & Axle Automatic, Automatic 4 Spd 95-05 Chevrolet CV Axle Assembly. Replacement Chevy CV Axle Assembly Parts. 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 95 96 97 98 99 00 01 02 03 04 05

shift solenoid for third gear maybe bad up inside the transmission pan

Trans fluid maybe low, and/or trans filter stopped-up. Drop pan...change filter...replace fluid.

You can take out either half shaft first. Doesn't matter. Yes you should install a new axle nut, if you bought new/rebuilt halfshafts they come with one. I have never had to use a special tool to get the shafts out. I also haven't had to replace the strut to knuckle bolt.

sounds like it might be a little low on trans fluid,and if i remember correctly these vehicles dont have a trans dipstick to check fluid level,but i could be wrong..if it does check it with the car running on a level surface and in park,hope this helps

Put a prybar between the shaft and the transmission and try to pop it out, it has a circlip holding it in. You don't remove the clip, it compresses when the shaft pops out.

The speed sensor for your 1991 Chevy Cavalier Z24 is located on the transmission just inboard of where the passenger side drive axle enters the trans-axle.

There could be a number of different problems here, the first thing I would check or get checked is the transmission oil levels, most auto-matic trans have a bilt in safety, when the oil is low it will not engage or drive..

will it go in with engine not running? if so look at slave or clutch master to be bad or clutch needs replacement,,,if it will not go into gear with engine not running,repair trans. or replace trans.

I have a 1998 olds Regency frt whl drive auto trans. Do not know the trans ref like 460 e? or what.
Any how have had a frt growl, vib @ 65 mph, up and down ride at 10mph. New balanced tires replaced lh whl bearing by guess mechanic said th whl brg was ok.
Latest Son checked the drive axles for movement--there is up and dn movement @ shaft into trans end --lh & Rh side also clunkie noise. Trans seal not leaking,yet.
I suspect brgs or a bushing in trans end as it accepts the drive axle. If it the problem is it replaceable after axle removeable??
John Pankow jpankowsenior@verizon