Mustang airbags i was wondering if the passenger air bags and the driver air bags from a 95 mustang v6 fit a 2000 v6 mustang

Hello Collette,

(Owner Manual Page 2-68)
The passenger sensing system turns off the right front
passenger frontal airbag and seat-mounted side
impact airbag under certain conditions. The driver
airbags and the roof-rail airbags are not affected by the
passenger sensing system.
The passenger sensing system works with sensors that
are part of the right front passenger seat. The sensors
are designed to detect the presence of a properly-seated
occupant and determine if the right front passenger
frontal airbag and seat-mounted side impact airbag
should be enabled (may inflate) or not.

I'm not sure if a purse or other light weight objects would activate the passenger airbag but if your display is showing random passenger activation it would be best to have a qualified dealer check into it...better safe than sorry.
http://www.gm.ca/media/owners/manuals/2010_Chevrolet_Malibu_Manual_en_CA.pdf

No your mustang will run as before
If the flashing light bothers you get the control unit to ignore it by disabling the airbags sensors

airbags are dangerous to work on for home mechanics.problem with airbags best to let dealership fix.if you can remove passenger airbag by disconnecting negative battery wait 20 minutes, beforeworking on the airbags. you have to remove glovecompartment to remove airbag mounting screws in the dash.

It means you have high resistance in the drivers or passengers side air bags... Heres the deal. check if the vehicle has side airbags usually noted on the side of the seats with the word air bag.. if there are no side air bags in the car than someone has put the wrong module in the vehicle. If it has side air bags go under the seats and check all electrical connectors to see if wires are broken or anything is unplugged. sometimes they unplug themselves from moving the seats or putting things under the seats.

drivers air bag is simple...
on the side of the steering wheel you will find two little circles/plugs that need to be removed. once removed there will be two little bolts, possibly torx. once removed the air bag is unplugged and removed

passenger side is a little more difficult and there are 6 bolts, 8mm if I remember correctly.

however, if you are replacing them because of an accident then you will also need to replace the clock spring in addition to the crash sensors

drivers air bag is simple...
on the side of the steering wheel you will find two little circles/plugs that need to be removed. once removed there will be two little bolts, possibly torx. once removed the air bag is unplugged and removed

passenger side is a little more difficult and there are 6 bolts, 8mm if I remember correctly.

however, if you are replacing them because of an accident then you will also need to replace the clock spring in addition to the crash sensors

Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.


Just push it together properly and it should clear the AirBag fault

The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.

Air Bags For S-Series Should Fit 2000-2002 All. SDM's there are 2 part # 's One for Standard Air Bags & One For Air Bags With Side Curtain Inflators!!