How to replace front wheel bearing on 2003 GMC ENVOY

SOURCE: 2002 gmc envoy xl front wheel bearing assy replace

take the wheel off,take the axle nut off,disconnect the spindle from the ball joint or joints, take the tie rod end out of the spindle and remove the spindle leaving the axle in the transmission. Now there is three bolts on the back of the spindle take theese out and beat the hub and bearing assy out. The new one wont be as hard to put in as the old one was to come out.

SOURCE: wheel bearing noise

from my experience I would replace them rather than trying to service the old ones, I had one fail completely after i had it "Serviced"

Mike Butler

• 6674 Answers
• Posted on Jul 26, 2009

SOURCE: ABS light won't go off

Any chance you damaged or moved wheel speed sensor, or got grease or something on it? I'd check that & make sure, (compare to opposite side) it's clean & spaced same from wheel as other.

SOURCE: fixing a 2003 ford focus front wheel bearings

remove the hub and spinle ,tie rod end ,axle nut.ball joint,and seperate from strut and then have new bearing pressed in...or rent a bearing press that works with an impact wrench,but they are a little hard to work with...good luck...lee

SOURCE: how do u replace a front wheel bearing on a 2005

Remove center hub cap. Remove large nut behind hub cap.Lift wheel assembly off ground. Remove wheel. Remove brake calipher assembly by taking out larger bolts from back of calipher. Remove brake rotor. Pull axle toward middle of vehicle, you may have to tap axle end with small hammer being careful not to damage threads on end of axle. Remove three bolts from back, bearing housing should come out to the front.