Timing diagram i am looking for a timing diagram for a 1997 Hyundai lantra 1.8

Sounds like you have a issue with the starter .

Check the fuse. Also make sure your dimmer for the dash lights does is not turned all the way down. If all that checks out, your dimmer may be need replaced.

You can get that in pieces from the service and repair manual. You can download that for a small fee here.

Throttle position sensor, check that, or fuel pump/filter

The horn is on the rad support ,passenger side.

1998 Hyundai Lantra "G4GM" engine 1795cc.there are two heads or blocks, one is called the M10, other is the M12, figure out which one you have cause the torque is different for stage one by 5nm........... Dont get confused theres 2 different engines so 2 different torques for stage1---------
heres the full details: Stage 1 - m10 = 30nm / m12 = 35nm-------------------------- -------- Stage 2 - tighten by 60-65 degrees ------------ stage 3 - tighten by 60-65 degrees. no sequence is given in the data book for tightening so go off what you thinks right, it doesn't matter on this engine.

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle. There is a TSB (Technical Service Bulletin) regarding the timing chain noise.

Click on link scroll way down to your 1.8L, and click on picture for bigger view.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528007385b