I have a 96 Honda accord. Check engine light came on and was diagnosed as system to lean. Would like some ideas as to avoid taking it to dealership.
Code 271 is for a problem with the injector for cylinder number 4. The circuit has higher voltage than normal. Possible causes are a faulty injector, dirty injector, or problem in the harness.
A mechanic would check the circuit and the injector with a meter.
Why would you take any car to a dealership?
Never a car over 5 years old
PO271 Cylinder #4 Injector Circuit High
Take to a local repair shop
You won't have the ability to diagnose
SOURCE: check engine light
You need change the Automatic Transaxle sensor or get Automatic Transaxle serviced ,please contact the dealer get it fixed or any other service center...........
SOURCE: I have a 96 Honda
is it a vtec if so check oil level as if gets low causes problems with the variable valve timing due to low oil pressure which causes poor performance and brings on mil light.
SOURCE: 1998 honda accord check engine light on code p0141
SECONDARY HEATED O2 SENSOR HEATER CIRCUIT FAULT SENSOR 2.
SOURCE: 2002 Honda Accord V6 check engine light on- local
po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy
SOURCE: 2005 Honda accord check engine light. is there a
Auto Zone can scan for free. There is a lot of sensors that can triger a fault code.
221 views
Usually answered in minutes!
×