Question about 1991 Jeep Wrangler
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The bleeder screw is located on top of the slave cylinder. It will not work right until it is properly bled.If the reservoir runs dry, you will have to start all over. Have an assisstant pump the clutch pedal 3 times with the bleeder screw closed...then hold the pedal down and open the bleeder screw. Don't release the pedal until the screw has been retightened...continue this process untill no air bubbles come out of the bleeder screw....don't let the resevoir run dry...Please rate this...
Posted on Sep 18, 2008
This is not a bleeder hole, this is a weep hole like in a water pump to see when there is seepage past the seals.
Bench bleed the system. With the master cyl. line and slave cyl assembled, place the master cylinder in a vise, fill the master cyllinder. actuate the slave cylinder back and forth lower than the master cyl. This will allow the air to escape upwards back into and out of the master cyl.
Once bled the system can be installed.
Posted on Oct 02, 2008
SOURCE: 1991 jeep wrangler clutch
U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.
Posted on May 13, 2009
If it has flanges on both ends, just unbolt it and replace. If it has welded pipes you will need to cut it off and use adapter sleeves and clamps. Really not rocket science...at worst, you may need to remove the hangars on the rear portion of the system to get enough room to install.
Posted on Jun 17, 2009
Tips for a great answer:
Aug 18, 2011 | 1991 Jeep Wrangler
May 01, 2011 | 1991 Jeep Wrangler
Jun 15, 2010 | 1991 Jeep Wrangler
Mar 09, 2010 | 1991 Jeep Wrangler
Jan 27, 2010 | 1991 Jeep Wrangler
Jan 14, 2010 | 1991 Jeep Wrangler
May 13, 2009 | 1991 Jeep Wrangler
Feb 09, 2009 | 1991 Jeep Wrangler
Feb 06, 2009 | 1991 Jeep Wrangler
Mar 04, 2017 | 1991 Jeep Wrangler
269 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: