Starter not getting power when you turn the key
SOURCE: 2001 elantra master power window switch
at the bottom and top of the switch there are retaining tabs. you can try to pop it out at those points with a flathead screw driver, but it is sometimes easier to just remove the door panel to get it out.
SOURCE: Ignition key will not turn...It's
Wayneard is correct. with one hand on the ignition key try to turn the key towards start. With your other hand hold the steering wheel and turn slightly in either direction. This will take the locking pressure off the ignition cylinder. To prevent this from re-occuring be sure steering wheel is in a straight position before removing key from cylinder. Then be sure not to use steering wheel as a lifting point to get out of the car. If you do the wheel will move into a locked position, which is what you are experiencing now. Keep me posted
SOURCE: How to replace headlight bulb hyundai elantra 2004
yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx
SOURCE: how to remove brake drum rear wheel 2004 Hyundai Elantra
Jack up rear of car till tire is off the ground.
Remove lug nuts & remove wheel.
Remove phillips screw(s) from drum.
Using a hammer, strike the drum to loosen it from the hub.
Remove drum by simutaneously turning it and pulling it outward away from the vehicle.
SOURCE: How to replace 2004 Hyundai Elantra starter
First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.
349 views
Usually answered in minutes!
×