2008 civic where is washer pump fuse

Fuses, but not mentioned as it goes via Wipers

2009 Ford Escape windshield washer not spraying? - iFixit

https://www.ifixit.com > Answers > View > 2009+Ford+...
Mar 2, 2015 - The pump is bi directional and is fused thru the front windshield wiper fuse. If the wipers work but the pump doesn't, ether the pump is bad or ...

Ford Escape (2008-2012) fuses and relays

https://fuse-box.info > ford > ford-escape-2008-2012-f...
The fuse panel is located on the right-hand side of the center console, by the instrument panel behind the cover. The location of the fuses in the passenger ...

Check for the whirring sound of the water pump when you pull the wash switch. It is located at the bottom of the fluid container. If no sound, the pump maybe dead. Check voltage supply at the connector to the motor too.

Hard to say what's wrong without testing thing's . Is there B+ voltage to the wiper switch ? B + voltage to the wiper motor ? Do you know how to use a voltmeter ? How to test electrical circuits ?
Here is a factory service manual list of componets involved .
Wiper/Washer System Components
The Wiper/Washer System consists of the following electrical components:
• Accessory relay
• Heated washer nozzles w/XA7
• WASH NOZ 10A fuse
• Windshield washer fluid level switch
• Windshield washer pump motor
• Windshield wiper motor
• Windshield wiper motor module
• Windshield wiper/washer switch
• Wiper/washer switch 10A fuse
• Wiper motor 30A fuse

Do you know how the wipers work ?
Windshield Wiper Motor Wiring Tutorial
Wipers Inoperative - All Modes ?????
Wiper Motor Switch Troubleshooting

Could be that the switch that activates the washer pump is not closing and that explains why the pump is not working. That has a separate switch from the wipers because you only activate it on demand.

Would need to scan vehicle to insure the wiper speeds are controlled by the General Module or a wiper intermittent relay....if relay...would locate and replace...if general module.....a reprogram or software update could be in order...possibly replacement.

Scott, Porsche Master Tech 35 years

On some older cars the washer motor circuit is tied into the wiper circuit, so the large fuse or relay for the wipers also controls the washer motor.
Don't know about your car, but you could take the connector off your washer motor and check for power there, when someone holds the washer pump switch on, and key on.

First and for most, check the fuse, that has probably burnt out. I am pretty sure that is the issue. Next if after finding fuse in panel , and replacing it, still don,t work, then next step would be checking washer/wiper motor. Thanks, please let me know, mike from fixya

Can you hear the washer pump running when you operate the washer switch? The washer pump is in the bottom (side) of the washer fluid reservoir. You should hear it running. If not, you can disconnect the wire connector at the pump and use a test light to check to see if there is power and ground at the connector when you operate the switch. If there is power and ground, replace the washer pump motor. If there is no power or ground, you most likely have a bad washer control switch. (You have to replace the entire Multifunction Switch)

If you can hear the pump running, check for washer fluid pouring on the ground. If this is the case, you have a broken hose between the washer pump and the jets that spray on your windshield.

Also note that there is no way possible that your problem could be CAUSED by a fuse!
For more information on this subject, please review this article: Where's The Fuse?

more then likely it is the motor that is bad or the plug may be bad. located on bottom of filler. Good Luck Tim

Fuse no. 7(10amp) in interior fuse panel and fuse no.110 (30amp) in underhood fuse panel