Question about 1995 Toyota Tacoma

1 Answer

1995 Tacoma heater works only in recirculation mode

Undercoated a the carriage a week ago. began then. Gets hot slowly only if warming the recirculated air. Goes cold quickly on fressh air mode. Doors and controls seem to operate appropriately.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 208 Answers

Hi, 2 possibilities exist.
1)The heater tap could be seized - to locate, follow the heater pipes that go tthrough the firewall back towards the motor, One of these will have a block on it with an arm and cable connected to it, check that the arm moves freely
2) the thermostat could be stuck open - this involves a bit more work to fix

Posted on Dec 08, 2012

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
crapiemael
  • 241 Answers

SOURCE: my 2001 toyota tundra heater wont blow hot air. I

If you've changed the coolant recently, it could be air locked in the heater core. To remove park the truck with the front higher than the back and remove the radiator cap. Start the engine and let it run while watching for a big air bubble burp coming out the radiator neck. Top off the coolant and continue.

Posted on Nov 18, 2009

  • 290 Answers

SOURCE: No heat/defrost 01 corolla

Sounds like you have air trapped in the heater core when you flushed the heater core. loosen the upper most heater core hose and run the engine untill coolant seeps out. Wait until the coolant has reached running temperature.

Posted on Jan 18, 2010

dttech
  • 4803 Answers

SOURCE: My car heater heats a

Yes, it sounds like a thermostat problem. However, low engine coolant level can cause the same symptom. Check the coolant level in the radiator when the engine is cool. If it is full and the level in the coolant reservoir is also full, then you probably need a thermostat. If the coolant level is low, I would recommend having your cooling system pressure-tested to find out where it is leaking from.


Has this been helpfull? If so, please take a moment
to provide some feedback by rating my answer.

Posted on Jan 16, 2011

Testimonial: "Thanks so much for the quick and easy-to-check answer. I appreciate you techies taking time to help me out. I will check the coolant immediately--"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 Toyota Corolla and heat on the left side and the right side is cold, what to do?


Heat is blowing on passenger side, but cold air ... - RepairPal

repairpal.com > Questions > Dodge > Ram 1500 > 2002 Dodge Ram 1500
Dec 7, 2009 - When I turn on the heat, the passenger side is receiving warm/hot air but ... blow hot air on the drivers side and it would get cold right away. about a week ago... I have a 2008 Dodge Ram 2500 SLT. ... Regardless of the settings cold air blows from the left vent and on the floor on driver and passenger sides.

Temperature Blend/Recirculation Doors May Fail and ...

repairpal.com > Problems > Jeep > Grand Cherokee
2008 Jeep Grand Cherokee143,000Visitor. I get cold air on driver side and warm air on the passenger side. Upvote (29) ... right side air is always at the coldest. no heat on the right side and air temp will not change, left side works good. .... Models: · Honda Accord; ·; Toyota Camry; ·; Honda Civic; ·; Acura TL; ·; Toyota Corolla ...

Heating and AC Temperature and Air Delivery Mode Do


Jan 16, 2016 | Toyota Cars & Trucks

1 Answer

A/c putting out cold air. on passenger side warm air on driver side. Had it recharged 2 weeks ago. What would cause this problem?


Check the heater motor actuator, in the inside in about the center under the dash attached to the heater duct. The actuator is a small motor that opens and closes the door on the air unit to direct the hot or cold air. One of the doors is not closing from the heat side of the unit.

Oct 11, 2015 | 2005 Chevrolet Malibu Maxx

1 Answer

08 dodge nitro blows hot air on passenger side but cold air out the drivers side!! Any answers




NOTE: LHD model shown. RHD model similar. All vehicles are equipped with a common heater, ventilation and air conditioning (HVAC) housing assembly (1). The heating-A/C system combines A/C, heating, and ventilating capabilities in a single HVAC housing mounted within the passenger compartment behind the instrument panel. The HVAC housing assembly includes:
  1. Mode-air doors (2)
  2. A/C evaporator (3)
  3. Recirculation door actuator (4)
  4. Air inlet housing (5)
  5. Recirculation-air door (6)
  6. Blower motor (7)
  7. Blower motor resistor (8)
  8. Heater core (9)
  9. Air distribution housing (10)
  10. Blend-air door (11)
  11. Blend door actuator (12
  12. Floor distribution ducts (13)
  13. Mode door actuator (14)

Jan 28, 2015 | 2008 Dodge Nitro

1 Answer

Heater and air condioning switch keeps making clicking noise


The noise is one of the actuators that moves the air flow doors into different positions. Common problem. When the noise happens, move the temp. control from cold to warm. If the noise goes away, it is the temp. actuator. Or, press the recirculation button to go from fresh air to recirc. If the noise goes away, it is the recirc. actuator. Or, change the mode from vent to heat. Could be the mode actuator. Usually the temp actuator acts up.

Sep 17, 2013 | 2007 Chevrolet Chevrolet Impala LS

1 Answer

My 2006 Ram 2500 Diesel cab heater blows cold are out the driver's side vents and hot air out the passenger side. I can't get the cab warm in the winter unless I place the heater in recircula


CHECK all the vent hoses, are they connected, no ob strucctions, when the last time you replaced the cabin air filter ? do you have one? look @ your owners manual, also, you may need to have several heater controls, or other control on as well, see owners manual, anything fall into the defroster vents ? replace thermostat @ engine. see how this works for you, good luck

Jan 28, 2013 | Dodge Cars & Trucks

1 Answer

Honda Accord LX has bad temperature control switch? I just got my A/C recharge with new freons and it is working. Before it was just blowing hot air when A/C is switch on and the A/C control knob turned to...


  1. what year model is accord?
  2. there are several doors in the air box
  3. blend door (hot cold)
  4. mode door (defrost, floor, vent)
  5. recirculation door (outside air)
  6. if the control mechanism is defective. the tech may have reached under the dash and manually opened the blend door.
  7. which control knob does not work mode or temp?

Jul 26, 2010 | 1994 Honda Accord

1 Answer

Cold air, engine light on, & gets hot very quick


Check coolant level first. That's your likely culprit.

Feb 18, 2010 | 2002 Ford Taurus

1 Answer

Heat control problem-air will not go to the floor. Your feet get cold and your head gets hot!


Your truck has an electric motor that runs the mode door.It is a pretty common problem that goes wrong.There are three motors under the dash one runs the recirculation/fresh air door,one runs the blend door (hot/cold) and one that runs the mode door that is the most likely cause of your problem.let me know if this helps or you need more info.

Feb 07, 2010 | 2007 Dodge Ram Truck

1 Answer

Heather blows intermittent cold air


It sounds like you need to go to the shop. the blend doors control the air flow, heat, and distribution. There are about 6 to 7 motors in all. They most likely need to be recalibrated. There is also a possibility the Climate Control Module Software will need to be upgraded. There is a small chance that there is a bad blend door motor that is crashing the communication link between the motors and the module.

Either way it goes only the dealer, or mabey a very heavily invested independent shop.

Hope this helps.

Dec 23, 2008 | 1998 Volvo V70

Not finding what you are looking for?
1995 Toyota Tacoma Logo

471 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...