Fixed my ABS but the warning light is still flashing, is there a way of reseting it. before i change my pump and waste lots of money
SOURCE: Ford Mondeo Mk3 Estate 2L. Air bag / seat belt Warning Light
Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.
Just push it together properly and it should clear the AirBag fault
SOURCE: Tried turning on ignition and pump gas pedal three times, but light still flashes
Look in you owners manual if you have one, It should tell you there.
If not call one of your local jiffy lube or minit lube, they should be able to tell you how to reset it.
Good luck
SOURCE: abs light on
They had to disconnect the abs in order to change the pads so it set off the abs light. you can just drive for a while and it might go away or you can disconnect the battery for 10 seconds but be careful the car player might ask for the code in order to play it.
SOURCE: abs and traction control light stays on
Cheapest option would be to have the fault code read by a dealer or specialist. Its likely to be a wheel speed sensor but its finding which one that's the problem. You could disconnect each one and take an ohms reading across the connections. They should all be the same or there abouts. Change the one thats not. If your lucky the light may extinguish. If not the fault will need to be cleared using diagnostic equipment.
Cheers John
SOURCE: dasboard lights flash and warning beep operates (Seat Leon 2001)
flashing dashboard lights when the ignition is turned off
4,567 views
Usually answered in minutes!
×