LOST KEYS AND CAN NOT OPEN THE DOORS BECAUSE CENTRAL IS ON AND CAR BATTERY IS FLAT. NEED TO HAVE KEYS CUT AS WELL AS OPEN THE DOORS

SOURCE: Central Locking does not work

You must reset your remote control in order for the lock/unlock to work properly.

To reset remote you would:
1)Insert Key in Ignition Turn to Position 1(Don't Start the Engine) for about 5 seconds
2)Turn Key Off and HOLD the LOCK button on Remote while pressing the UNLOCK 3 TIMES
3)Release both lock and unlock buttons you are holding
4)All doors should automatically unlock

And exit the door and lock with the Remote.

SOURCE: the key will not operate the central locking

if it wont turn fully to open, theres a little spring loaded pin in a u shape in front of the barrel that breaks this needs to be replaced,

SOURCE: CENTRAL LOCKING NOT WORKING

central door locking need further information, but to petrol in is very simple: in the right hand side of your boot straight behind the fuel door you find a cable, if you pull it it will release the door

SOURCE: central locking in my bmw 320 diesel isnt working

Providing central locking works when you insert key in lock,try programming keys
Enter car make sure all doors/windows are shut
Switch ignition on and off,remove key
PRESS AND HOLD UNLOCK BUTTON ON KEY
Press lock button on key 3 times whithin 10 seconds and release unlock
Central locking will lock/unlock rapidly to confirm reset
If your key is the type with bmw logo in the middle battery replacement is not possible,as it charges as you drive

SOURCE: central locking does not work on my BMW 320D SE model

hi

there is a motor placed inside the doors for the operation of the central lockin system. when you open the door by key this motos is activated and all door locks are released. your problem may because of this motor is failed.

cause of the failure
1.the wire going to the motor may be chopped off.
2.the junction box connecting the wires may be damaged.
3.fuse may be blown out.
4.motor itsef damaged.

so please check weather power is coming to the motor using multi meter. if the power is not coming to it then the problem is with the wires. if the power is coming to it then problem is with the motor.

i suggest you to take to BMW because you need to remove the door pannel its better if they do it.


please vote me if my answer was useful to you.