Question about Cars & Trucks
Crank sensor tests ok do get anti theft code but mechanic says hat is secondary
Check if the injectors are pulsing when cranking the engine over. Listen for the tick, or feel for the pulse with your fingertips, or buy a cheap "noid light"-an injector circuit tester- one that fits your injector harness connectors-plug it into an injector connector and crank the car. If circuit is working the noid light will be flashing.
Some anti-theft systems immobilize the injector circuit when they are activated. So you have spark, compression, and fuel to the engine, check the injector circuit.
Posted on Dec 01, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2004 kia optima
Try the ignition switch,
For the Crank sensor there is a small metal disc that mounts behind the sensor if that is cracked or dammaged or installed backwards you will get same results as if it wasn't Make sure the timing marks line up on your timing belt. www.kiatechinfo.com
Posted on Jan 19, 2009
It sounds like the vehicle is in theft mode,did you use a different key? Does the theft light blink really fast with the key off?If the passive anti-theft system has been activated the computer will have to be reset in order to get the vehicle running again.
Posted on Apr 26, 2009
try to start the car, than the anti theift would shut the car off. you wait ten min with the key on, until you see the anti theift flash or disapear. than turn key to off position and try to start it. this will reprogram the computer.. Good luck.
you can also try disconnecting the battery for 30 minutes
Posted on Oct 07, 2009
The sensor is part of the ignition key lock cylinder, so the part and labor will be around $200-$300 depends on your local labor rate, the dealer must do this repair because the new lock cylinder key code must be programmed into the VATS module.
Posted on Dec 10, 2009
did you use aftermarket crank sensor? if so that might be your problem. dealer has several different ones, by providing vin number, but there is only one after market for all optimas 01-05. try to connect thick pink wire and thick orange wire together on the ignition failure sensor. you might have the same problem as me. good luck.
Posted on Jan 15, 2010
Tips for a great answer:
Dec 13, 2016 | Ford Cars & Trucks
Nov 15, 2013 | 1998 Ford Explorer
Jan 30, 2013 | 1998 Mazda Protege
Jun 29, 2012 | 1995 Ford Explorer
Jun 26, 2012 | 1998 Volkswagen Jetta
Aug 25, 2010 | 1994 Chevrolet S-10 Blazer
Mar 13, 2010 | 1998 Ford Explorer
Jan 09, 2010 | 1999 Ford Explorer
Jan 07, 2010 | 1998 Ford Explorer
174 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: