Head bolt specs and cam caps
3 layer head gaskets torque to 22 ft/lb then 60°-65° then 60°-65°again.
2 layer head gasket torque to 18 ft/lb then 60°-65° then 60`-65° again
M10 bolts
3 layer head gaskets torque to 22 ft/lb then 60°-65° then 60°-65°again.
2 layer head gasket torque to 18 ft/lb then 60°-65° then 60`-65° again.
M12 bolts
3 layer gasket 26 ft/lb then 60°-65° then 60°-65° again.
2 layer gasket 22 ft/lb then 60°-65° then 60`-65° again.
What do u mean by 3 layer or 2 layer gasket
×
SOURCE: i have a 1997 hyundai elantra 1.8 i need torque specs. for head
go to http://www.hmaservice.com/ and register. After that, you'll have access to manuals, service bulletins, wiring diagrams, etc.
SOURCE: Correct torque on cylinder head bolts for Hyundai Elantra 1.8GLS
You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM
(2) Using several steps, uniformly install and tighten the 10 cylinder head set bolts and plate washers with a 10 mm bi-hexagon wrench in the order shown in the illustration. Torque: 
(d) Further tighten the cylinder head bolts 90° as shown in the illustration.
Torque: 
2,541 views
Usually answered in minutes!
×