Where do I find an uncut stock key for a 1994 Geo Prizm LSi that has the geo logo on it? I'm looking for a blank copy of the stock key for this car. This is the one with the Geo logo on it. I have a working copy of the key, but it is a cheap Walmart key, and I want to get the stock key for the car cut to match it. I can't find any of these keys though. Here is a picture of the key. I could only find it along with an ignition on ebay, but at least there is a photo for reference of what it should look like. http://i.ebayimg.com/t/N5-95-GEO-PRIZM-IGNITION-CYLINDER-DOOR-LOCKS-W-KEY-/00/s/NzY4WDEwMjQ=/$(KGrHqN,!ocFBY9N)sH,BQ,hOrqL2w~~60_57.JPG
SOURCE: 1996 geo prizm
you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.
SOURCE: 1994 GEO Prizm Fuel Guage
You need to replace your fuel sending unit. It is located inside of the gas tank.
Please remember to rate this solution.
SOURCE: 1993 Geo Prizm Lsi Harmonic Balancer
Yes a harmanic balancer from tha corolla is the same thing. I had to do the same thing with my 95 geo. It works out to be a lot cheaper buying for a toyota than a geo.
SOURCE: 1994 Geo Prizm LSI running one day won't crank next day
turns over and crank are the same thing,
so you are saying it does crank over but no start,right?
you need to determine if you have at least 50psi of fuel pressure in fuel rail at reed valve.
SOURCE: My '97 Geo Metro LSi will not start. When I turn
It could be the starter, test the small wire going to the starter, it should have power when turning the key to start/crank. If it does, and the starter will not crank the engine, whack it with a hammer, if it then starts, replace the starter. If there is no power to the starter, then it could be the ignition switch, or the neutral switch, or a fuse/link blown.
64 views
Usually answered in minutes!
×