Cars & Trucks Logo

Related Topics:

Anonymous Posted on Nov 29, 2012

ENGINE KEEP RUNNING AND DASH LIGHTS FLASHING AFTER CAR IS SWITCHED OFF

WHEN YOU PRESS BRAKE ENGINE CUTS OF SOMETIMES AND DASH LIGHT FLASHES

  • Anonymous Nov 29, 2012

    1993 500sel

  • Anonymous Dec 03, 2012

    found wire burnt off starter, replaced it and car is ok so far

×

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Expert 344 Answers
  • Posted on Nov 29, 2012
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Nov 27, 2012
Answers
344
Questions
0
Helped
70639
Points
914

You got a problem that has to be check out at the dealership

3 Related Answers

Anonymous

  • 1118 Answers
  • Posted on Mar 10, 2009

SOURCE: Brake lights dont work, Turn Signals all goofy

First thing i would do is chg. the break light switch, and make sure to chk. all grounds around tailights, sometimes if there is a ground problem it will travel back thru the hot wire to get a ground, witch in turn makes everything go wackey.

Ad

Anonymous

  • 4669 Answers
  • Posted on Apr 08, 2009

SOURCE: 99 pontiac transport- tcs,abs,emerg brake and low traction(flash)

Have the ABS system scanned for codes. The ABS and Traction control use the same computer. You likely have a bad wheel speed sensor.

Anonymous

  • 22 Answers
  • Posted on Apr 17, 2009

SOURCE: n reg vw polo engine cuts out at junctions when headlights are on

first clean throttle body out with carb cleaner and some clean cloth , if the throttle flap is dirty the car will stall

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Abs flashes on and off on dash then brake light flashes on and off brake lights flash when dash lights flash

dashboard brake light flashing randomly - Forums.focaljet.com

forums.focaljet.com/.../662231-dashboard-brake-light-flashing-randoml...

May 14, 2012 - 12 posts
Car run great the only issue is the dashboard brake light is flashing randomly. ...Finally, the instrument cluster is hardwired to the ABS module, ... Also,i change the parking brake switch and the light goes on & off less frequent.

what does ABS flashing light mean at the dashboard of my 1996 ...

https://answers.yahoo.com/question/index?qid...
May 3, 2009 - What does ABS flashing light mean at the dashboard of my 1996 ... just hard enough to skid a tiny but, then back off a hair to stop skidding.

ABS Brakes Troubleshooting - How to Troubleshoot Anti ...

www.popularmechanics.com/cars/how-to/a461/2265091/
0helpful
2answers

How do you change the brake light switch on a 1999 lincoln town car?

go under the dash to the brake pedal you will see a rectangular switch with a plug sticking out of it when you move the pedal the spring push's in the plunger for lights to work this is it you'll find a hitch pin on one side holding the switch in place remove the pin and slide the switch off assembly is the reverse of removal
0helpful
1answer

3.0L 2000 DODGE CARAVAN SHUTS DOWN WHEN STOPPING AT A LIGHT OR STOP SIGN. NO LIGHTS ON DASH - NO ENGINE LIGHT. TURN KEY OFF AND RESTARTS OK. MUST KEEP FOOT ON GAS PEDAL AND BRAKE PEDAL TO KEEP ENGINE...

it sounds like it is starving for fuel, the fuel filter may be clogging up. when a fuel filter gets dirty and cuts some of the flow of fuel, it will stall out at stops. because the engine does not have the proper amount of fuel to keep it running. have a good day !
0helpful
3answers

1992 GTI, Mk2, 2L(2E) 8valve. Engine cuts out sometimes when car comes to a halt and has to idle, this occurs whether the engine is hot or cold and anytime of the day or night. Another thing i noticed...

Hi

the cause wil be the air mass meter also known as the air mass sensor, when this fails the car struggles for air and hence cuts out, this is made worse when the lights are on at night as the car will be trying to compensate the failed air sensor with more power so it will **** more power from the battery to keep the engine running, when you put the lights on it wil make it harder for the altenator to provide power to everything at once, very common fault on this car.

Regards

Dan
0helpful
1answer

Brake pressure light flashing- red light on dash stays on

if brakes work ok leave well alone ,this sounds like an electrical fault that big money to repair.At the end of the day the brakes are failsafe manually operated
0helpful
1answer

The green light keep flashing and it dont stay on

The green light on the dash flashes when the lights are off or if you have just the day time running lights on. If your lights are on the light should go out. or if a head lamp is out it may stay on
0helpful
1answer

Brake lights dont work, Turn Signals all goofy

First thing i would do is chg. the break light switch, and make sure to chk. all grounds around tailights, sometimes if there is a ground problem it will travel back thru the hot wire to get a ground, witch in turn makes everything go wackey.
5helpful
1answer

Dash lights come on when I press the brake peddle

Sounds as if your getting a back feed. Most likely from the brake light bulbs (part number 1157). Take out the brake light bulbs and see if the dash lights still come on when you step on the brakes. If so check the lead contacts on bulbs, sometimes they get squished/corroded and jump both contacts, replace bulbs with new and recheck. Hope this helps.
Not finding what you are looking for?

107 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...