Here's a link to the cylinder location.
Click the link below and view exact cylinder diagram the order is ascending 1-2-3-4-5-6.2005 KIA Sedona Ignition coil Cylinders
http://technoanswers.blogspot.com/2012/11/2005-kia-sedona-ignition-coil-cylinders.html
----------These will help.Thanks.
Testimonial: "Thank you. It was a spark plug and the coil on top"
I hope this diagram helps.
SOURCE: i have codes po430 and p2422 kia sedona
P0430 Catalyst System Efficiency Below Threshold (Bank 2)
P2422 Evaporative Emission System Vent Valve Stuck Closed
SOURCE: where is the crank position sensor located in 2005
Hello martinezmelm: My name is Roger and I can answer your question. To locate the crankshaft position sensor. You will need to remove the timing cover. You will find the sensor on top of the crankshaft gear. Between the V of the timing belt.
Should you need further help please just ask. Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger
SOURCE: help me to locate the fuel filter and fuel pump in the kia sedona
start of at the gas tank look under neath there are some black lines running towards the engine follow it to a small gold color that ataches to the line you are following that is the filter the pump is in the gas tank you need to drop the straps at the tank to bring it down
SOURCE: How do change the serpentine belt on a 2005 Kia
There is a tensioner pulley that has a nut in the middle of it, loosen that nut and there is a tensioner bolt that when you loosen it, it slides the pulley away from the belt to replace it.
SOURCE: where is the crankshaft position/crank
Hi, at the front of the crankshaft. if its near time for the timing belt, you want to replace it along with any pullies, tensioner and water pump
The crankshaft position sensor is mounted on the engine near the crankshaft.
Operation
The crankshaft position sensor is a Hall-Effect sensor that senses the crank angle (piston position) of each cylinder and converts it into a pulse signal. The signal from the sensor is relayed to the ECM to indicate engine rpm and the position of the crankshaft.
Removal & Installation
Temperature - 4°F, test specification 1500-1700 RPM Temperature 32°F, test specification 1350-1550 RPM Temperature 68°F, test specification 1200-1400 RPMTemperature 104°F, test specification 1000-1200 RPM Temperature 176°F, test specification 650-850 RPM
1,281 views
Usually answered in minutes!
×