Question about 2004 Jeep Grand Cherokee
This is one of those things where you really have to take it to a dealership. Because they way you adjust the idle control valve pendulum is with the DiamlerChysler Scan tool that all dealership service departments have. It's called the DRB scanner. After you remove and replace the IAC valve the scan tool performs a procedure call resetting the engine values. This will set the pointed pendulum on the IAC motor to sit to the throttle body. What I would tell you to do is remove the entire throttle body and clean it very good. All you will need is can or two of carburetor cleaner I use Berryman B-12 chem cleaner seems to work best for me and a old tooth brush. Remove the TPS and IAC motor from TB and clean any and all the carbon build up. So when you reinstall the IAC motor the pendulum will sit properly. If there is carbor build up in the TB no matter what you do it will not idle properly. The only parts and supplies you will need is a can or two of carb cleaner, old tooth brush, and a new TB to intake manifold gasket or O-ring. You may spend around $20.00 for everything. And this next is important. While you are working on the TB. Remove the negative battery cable from the battery post. And when you reinstall the TB. Reconnect the battery cable post. This will sometime reset all the engine sensor valves itself. After that put the key in the ignition and turn it on but don't crank it. Do that 2 or 3 times for around 5 to 10 seconds each. This may save you a lot of money instead of going to a dealership and paying those absolute ridiculous hourly rates. I worked for Jeep, Chysler, Dodge for several years in the R and D department. There usually always a back door. You just have to know where it is. Ha!! Hope this helps.
Posted on Nov 28, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The code you have is difinitely idle air control motor. I guess you could check continuity and compare to a known good unit, but this test may not be valid. Before condemming it though, make sure "business end" is clean and free of carbon or varnish. That applies to passage into plenum as well. If everything is clean then replace unit.
Posted on Jan 08, 2009
P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please
Posted on Oct 27, 2009
Tips for a great answer:
Dec 13, 2015 | Nissan Maxima Cars & Trucks
Jan 27, 2015 | 2002 BMW 3 Series
Aug 29, 2013 | 1996 Nissan 200SX
May 13, 2013 | Honda Civic Cars & Trucks
Nov 27, 2012 | Cars & Trucks
Jul 02, 2012 | 1999 Dodge Durango
Dec 16, 2010 | 1999 Dodge Durango
Mar 04, 2010 | 2000 Dodge Stratus
Sep 30, 2009 | Honda Odyssey Cars & Trucks
344 people viewed this question
Usually answered in minutes!