Question about Cars & Trucks

Open Question

Does the radio antenna wire go from antenna to radio or is it a 2 wire connction

Posted by on

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i have a 95 buick lesabre i bought from a friend everything works great sides the radio i have an after market stereo jvc model no kd-g320 not sure witch color the antenna wire would be car has a power...


Antennae wire and other wires for the stock stereo are listed below:
1995 Buick LeSabre Stock Radio Wiring Diagram
Car Radio Constant 12V+ Wire: Orange
Car Radio Ignition Switched 12V+ Wire: Yellow
Car Radio Ground Wire: Black/White
Stereo Radio Illumination Wire: Gray/Black
Stereo Radio Dimmer Wire: Brown/White
Stereo Radio Antenna Trigger Wire: Dark Green
Stereo Radio Amplifier Trigger Wire: N/A
Front Speakers Size: 5 1/4? Speakersir?t=modilife-20&l=as2&o=1&a=b00009uhre
Front Speakers Location: Doors
Left Front Speaker Wire (+): Tan
Left Front Speaker Wire (-): Gray
Right Front Speaker Wire (+): Light Green
Right Front Speaker Wire (-): Dark Green
Rear Speakers Size: 6? x 9? Speakersir?t=modilife-20&l=as2&o=1&a=b00009uhre
Rear Speakers Location: Rear Deck
Left Rear Speaker Wire (+): Brown
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Dark Blue
Right Rear Speaker Wire (-): Light Blue

Feb 19, 2015 | 1995 Buick LeSabre

1 Answer

I have a 2003 monte carlo. had the tint remove from back windo. the tab on the grid came off but the mechanic replaced it. now when I listen to my radio if I turn on the defogger it messes up my radio


Lol, there are actually 2 grids on the back window, one is for the defrost, the other is for the radio antenna. Your mechanic probably has the wires on the wrong tabs on the passenger side. He has the radio antenna on the defrost grid and the defrost wire on the antenna. Take it back to him ans explain your issue.

Sep 27, 2014 | 2003 Chevrolet Monte Carlo

1 Answer

What does fuse called radio-b do?


If your unit has digital display as most do now, RADIO-B will supply constant power to power the units memory so it can remember the preset channels, starting volume etc. The power antenna is usually controlled by a separate wire from the unit (normally blue) this wire supplies a low voltage signal to the antenna, The antenna will also have its own power supply and earth at the base of the antenna, the problem could be there. depending on the antenna, some have a controlling relay that is separate, again another possible source. there will also be a fuse in the main fuse box. These will all need to be checked, along with connecting a power source to the antenna to ensure the antenna does actually work.

Feb 23, 2013 | Cars & Trucks

1 Answer

Antenna motor keeps running. How do I disconnect?


2 ways you can do it> 1 find the fuse and pull it out but only if it is for the antenna or you can disconnect the antenna wire from the back of your radio, it is normaly a blue wire run with the power harness. Red is 12V. Black is Ground 0V. Yellow is Remote, it works with an AMP if you have one installed. Blue is normaly the power antenna. hope this helps> test it first by pulling the fuse to the radio and if the antenna does not operate then the power is from the radio

Jan 17, 2013 | 1985 Oldsmobile 98

1 Answer

RADIO ANTENNA LOCATION


Above the roof headliner.

Jul 26, 2017 | Audi A3 Cars & Trucks

1 Answer

I have a problem with my car radio , for some reason i cant find any radio stations , but CD work good . Please let me know how to fix this problem .all parts are original from beginning.


there could be a couple of issues 1 the antenna itself is broken 2 the antenna wire has gone bad or 3 the antenna input on the radio is bad these are the only real things that control the radio function i hope this helps

Feb 13, 2011 | 2001 Chevrolet Astro

1 Answer

Radio in 88 lincoln town car doesn't pick up stations but cassette works just fine. Everything is hooked up, harness, speakers wire, ground wire, and antenna. I also checked to make sure that the antenna...


Probably bad antenna wire at the antenna itself. Try plugging a piece of bare wire into the antenna hole (the 1/8" hole in the center) on radio, you should get something, hissing or some sound.

Feb 08, 2011 | 1988 Lincoln Town Car

1 Answer

How to replace thunderbird antenna


please rate service.

Automatic Electric Antenna
Removal
  1. Lower electric antenna (18850) .
  1. Remove rear retaining screws of RH front wheel splash shield for access to antenna lower retaining bolt.
  1. Remove lower retaining bolt.
  1. Remove radio antenna nut (18865) from top of motor tube and remove electric antenna through fender/splash shield access.
  1. Disconnect signal cable and motor wire connector(s).
Installation
  1. To install, reverse Removal procedure.
  1. Tighten top radio antenna nut to 6-8 Nm (54-70 lb-in).
  1. Tighten lower electric antenna retaining bolt to 5.8-7.8 Nm (51-69 lb-in).
  1. Check operation of electric antenna and radio chassis .

    Automatic Electric Antenna


    1faf511.gif

mast
Mast, Power NOTE: A power antenna mast which is bent or broken can be replaced without replacing the motor and tube assembly.
Removal
  1. Remove radio antenna nut (18865) and radio antenna stanchion (18919) .

    ssd~us~en~file=l6389b.gif~gen~ref.gif

  1. Loosen retaining nut inside tube using 14 mm (9/16 inch) socket, and slide nut part-way up mast.
  1. Raise antenna to run plastic drive wire at bottom of mast out of motor. Note direction of teeth on plastic drive wire.
  1. Saw off damaged portion of antenna mast. Remove burrs from mast and slide nut and contact tube off stationary tube.
Installation
  1. With the teeth on the plastic drive wire facing toward motor on antenna, push end of plastic drive wire of replacement mast assembly down into tube. Push it around curve at bottom of tube until end enters drive mechanism.
  1. Run motor down while pushing on plastic drive wire until about 305 mm (12 inch) of wire has been drawn into the tube. Stop motor and insert bottom of antenna mast into tube. Lower mast.
  1. Slide contact tube and radio antenna nut down antenna mast. Tighten nut to 0.45 Nm (4 lb-in).

  2. Raise and lower antenna several times to ensure proper operation.
651247a.gif

Jul 09, 2009 | 1995 Ford Thunderbird

1 Answer

Audio wiring problem


Radio Constant 12V+ Wire: White/Green
Radio Switched 12V+ Wire: White/Red
Radio Ground Wire: Black
Radio Illumination Wire: n/a
Radio Dimmer Wire: Red/Black
Radio Antenna Trigger Wire: n/a
Radio Antenna Location: Rear Glass
Front Speakers Size and Location: 6 1/2′ Doors
Left Front Speaker Wire (+): Blue/Green
Left Front Speaker Wire (-): Gray/Black
Right Front Speaker Wire (+): Red/Green
Right Front Speaker Wire (-): Brown/Black
Rear Speakers Size and Location: 6′ x 9′ Rear Deck
Left Rear Speaker Wire (+): Blue/Yellow
Left Rear Speaker Wire (-): Gray/White
Right Rear Speaker Wire (+): Red/Yellow

Apr 05, 2009 | 1998 Honda Accord

1 Answer

Hello. My antenna is connected to the back of my


The panel snaps on and off from the inside of the trunk up to the wheel well. There are 2 10mm bolts on the drive's side and 1 on the passenger side. You have to take the little cover off the driver side shock access to find the 2nd one. then pop the plastics off starting @ the trunk. There are 2 wires on the antenna unit; a single power wire on the motor, and the fat black antenna wire. If there is not a connector on the motor itself, you will need to get to the wires behind the radio and cut the "blank" wire WHILE THE RADIO is ON and the ANTENNA is in the UP POSITION! Failure to do this step will mean NO radio reception to speak of. DO NOT unplug ANY of the connectors on the back of the radio without first calling a dealer and getting the code to activate said stock radio. You will need this code if your battery goes dead as well.

Mar 26, 2009 | 1996 Acura Integra GS-R

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22400 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...