SOURCE: what is the marking for the timing belt setting for freelander landrover 2002
timing info on a 2002 landrover freelander v-6
SOURCE: hard clutch pedal
You cannot bleed a servo. it runs using the vacuum from either inlet manifold, or a seperate vac pump.Ensure pump is working if fitted (end of camshaft) the pipes to the servo are not leaking by removing the pipe from servo and start veh. If there is good suction then its servo failure. hard pedals can also be caused by pressure plate fatigue in the clutch itself.
SOURCE: hi i have a land rover freelander 00.back door
you have to unlock the door with the remote and then pull the handle and the window will lower about an inch and then the door will open
SOURCE: i need some fitting instructions for a rear window
as simple as i can put it here goes , you will need to remove rear door panel using a flat blade tool, start at top and work your way round to hinge side,peel back the weather sheild about six inches down all along the top edge , this will reveal the mounting points on the back of the rear panel, leave the removable ends attached to the window guard and line up against rear panel, check which hole's need to be used and attach brackets to these points using bolts supplied in kit or what ever you have to hand. once mounted you can pull guard from brackets and put to one side , next is the rear panel if you place panel face down revealing back it will show two ovalish shape's highlighted by faint outline , this is where you will need to cut and file . when that is finished you can reinstall rear panel on to door, install rear guard and locking bolts. it always handy to have spare clips for door panels as the become brittle with age.
Testimonial: "Brilliant - thank you...."
SOURCE: Low Fuel Pressure on Landrover Freelander TD4
From 53 reg onwards, diesel pump is under R.H. rear wheel arch, hidden by the plastic wheel arch liner. Older versions have combined fuel pump/sender in the tank (under R.H part of rear seat).
You should be able to hear a faint purr from the pump when ignition is turned on but engine not yet running.
322 views
Usually answered in minutes!
×