2005 Toyota ECHO Logo

Related Topics:

Posted on Jan 08, 2009

Plug replacement on a 2005 Toyota Echo 4 cyl engine

How do I replace the soark plugs on a 2005 Toyota Echo

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 15 Answers
  • Posted on Apr 09, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Apr 08, 2009
Answers
15
Questions
0
Helped
10162
Points
65

Hey alanacheson,
The spark plugs are underneath that cover on top of the engine (should say VVTi on the cover).
Just take that cover off, and then you will see the four ignition coils. Take off the four ignition coils (with igniters), and you will see the four relatively long holes underneath, and the spark plugs are at the bottom of those holes. You will need a good spark plug socket (preferably a thin wall socket) and a 6" or 12" extension. This is actually a very easy job, and can be completed in less than an hour.
Hope this helps.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

HDo I remove and install an idler pulley on a 2005 Toyota Camry?

How to replace drive belt tensioner Toyota Camry - YouTube

? 4:26
https://www.youtube.com/watch?v=gfSJvN-CE2E
Feb 22, 2013 - Uploaded by Fix It Angel
2002 2003 2004 2005 2006 2007 2008 2009 Toyota Camry. Engine, 4 cylinder, 2.4L, 2AZ-FE. 2004 Toyota ...

Idler Pulley, How to replace (EASY and CHEAP) - YouTube

? 4:56
https://www.youtube.com/watch?v=axAltpW8wR4
Nov 2, 2013 - Uploaded by ChrisFix
Idler pulley squeak? Learn how to fix a squeaky pulley in your car. The serpentine belt in your car powers the ...

2007 Camry Serpentine Belt Replace - 4 Cyl, 2.4 liter ...

? 4:21
https://www.youtube.com/watch?v=ejhyCrh96a8
Jan 13, 2013 - Uploaded by Flyin Brian
I show you step-by step how to get the old belt off and install a new ... ... Water pump replacement 2007 Toyota ...


0helpful
1answer

Number 4 cyl. misfire/ 2.4rz engine/98 toyota p.u. how to fix misfire of number 4 cyl.on toyota 98 tacoma p.u./2.4rz engine

check compression, check valve clearance, check injector for properly working, check for vacuum leak around this cylinder.
0helpful
1answer

What is the cylinder order for a 4 cylinder toyota camry

It is 1-3-4-2 with No 1 being at the timing belt and crank pulley end.
0helpful
1answer

02 Toyota Tacoma when engine warms up cylinder 3 has a misfire po303

check spark plug of the cyl. switch plug with another cyl, run engine until warm to see if misfire still comes on. if it stays on the same cyl. fault could be high tension wire or coil or worse leaky valve or rings. if misfire switched to the other cyl just change plug or better replace all plugs
0helpful
1answer

Replace spark plugs toyota echo

remove cover on top of engine 4 bolts remove plug boots and you will have access to the plugs
0helpful
1answer

2005 toyota echo two days before i wash engine. then engine working not smoothly some vibration and not going smoothly what can i do?

Sounds like you got the ignition system wet. Remove the coils, and dry out the spark plug wells. It would be a good idea to apply dielectrig grease sparingly to the inside of the plug boots.
2helpful
1answer

Replace spark plugs with plat core plug

Platinum plugs are NOT recommended for the Echo. The heat ranges are different. Put the right plugs in it (buy them from a Toyota dealer) and see if your problem vanishes. I get this quite a bit, customers put in new plugs, and it runs worse than it did before they changed the plugs. Note that ALL Toyota engines have a specific plug engineered for each engine. Platinums do not work unless the engine was designed for it. Same with iridium and NO Toyota runs well on the "split fire" plugs. If the problem persidts, change the coils around, see if the misfire "moves" to a new location, and you get a DTC P-0300, P-0301 and P-0302. If so, your coil pack may have failed, BUT, do the plugs first.
Not finding what you are looking for?

538 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...