Does anyone know the torque settings and sequence to tighten cylinder head bolts on an 03 e46 bmw compact
SOURCE: head light problem on bmw e46
if ur side light still works then ur bulb most likely blown my e36 has a screw connector on the back off the headlight dnt know if e46s do but maybe that has come loose?
SOURCE: Hi I'm looking for cylinder head torque settings for a 1992 BMW 316/318 e36
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
SOURCE: CYLINDER HEAD TORQUE SETTINGS BMW 318TI THANKS
hi this has to be done in 3 stages, leaving 20 to 30 minutes between tightening's they are as follows..
stage 1: 30Nm leave 30 minutes
stage 2: 90 degrees turn leave 20 minutes
stage 3: 90 degrees turn leave 20 minutes
you have to leave them this length of time so as not to put to much strain on the head in one go...hope this helps please vote thanks
SOURCE: bmw e46 316ti compact: Airbag red light on. What I
Yuo'll need to take it for diagnostic scanning to find out which air bag is showing a defect. The shop will then advise you.
Regards Johngee10
2,655 views
Usually answered in minutes!
×