SOURCE: WHERE IS THE FUEL FILTER LOCATED ON LAND ROVER DISCOVERY 2000
LAND ROVER DISCOVERY II DONT HAVE FUEL FILTER, ONLY HAVE PRE FILTER IN THE FUEL PUMP
SOURCE: Land rover Discovery 2004, rear right hand side down 2 inches
If you have the coil spring suspension, then your spring for that corner has really sagged[doubtful] I suspect you actually have the rear air suspension ,and the air spring for the Right/Rear has lost air, allowing the rear end to lower down greatly. Usually, you need a new air spring when one develops a leak. You may or may not be able to see the leak with a spray solution of soapy water after the spring is removed for inspection. Sometimes you have to apply about 20psi of air pressure into the spring to inflate it a bit, then put the spring under water in a big enough tank/tub of water to catch the leak that way.
SOURCE: Radio in 2000 Land Rover Discovery
THERE SHOULD BE A RADIO CODE CARD WITH THE VEHICLES PAPER WORK.IF NOT U HAVE TO CALL THE DEALER FOR THE CODE.
SOURCE: My son has a 96 Land Rover Discovery I that the
You need to start by removing the inner door panel, Remove screws that hold door pull and inside release handle. There are multiple plastic clips that have to be popped out. Use screwdriver but a trim clip removal tool works better.(Lisle tools part #35400). Once panel is loose unhook elecrical connectors to panel, peel back plastic vapour barrier, access to all latch parts, rods window regulator , etc is now available.
Testimonial: "Awesome!!! Thank you so much. My husband's fax number is 972-438-3945 put to the attention of Severt Nielsen. "
SOURCE: land rover discovery central locking.
No, likely to be caused by the actuators in the lock mechanism failing usually causing the door to remain locked. The boor door can also fail this way, as do the front side doors. Replacement requires the whole lock unit to be replaced at a cost of roughly £60 a lock, and a hours work. Helps if you have small hands. Requires a full strip down of the door and you will need the lock unit, trim clips (a few quid) and a trim removal tool (tenner). You can bodge with a flat head screwdriver, but the tool does help prevent damage to the clips & trim panel.
97 views
Usually answered in minutes!
×