Reset oil change for 2012 ford raptor

SOURCE: Oil Life Reset

Put the key in the ignition, and turn it on (don't crank the engine) while holding out on the small instrument cluster stalk near the clock. When the key is turned on, keep holding this stalk out, and push and release the other one (the one on the right). This should turn the "oil service" message to "----". Turn off the key and then release the left stalk. When you turn the car back on, the message should be gone.

Marvin

• 85242 Answers
• Posted on Feb 09, 2009

SOURCE: reset oil life display after oil change?

THIS SHOULD BE IT.
How do I reset the Engine Oil life monitor and how does it work? TO reset To reset the Engine Oil Life monitor do the following:
Reset Oil life in NAV/DIC by (with car running) going to INFO>Oil Life>RESET
Press and HOLD until XXX turns to 100%
How does it work? The oil life monitor is a pretty sophisticated algorithm.

GM "The GM Oil Life System will automatically adjust the oil change interval based on engine characteristics, driving habits and the climate in which the vehicle is operated."

SOURCE: How do I reset Oil Life warning Message

Turn ignition on,need not running.Hold the reset button in until oil life xxx% blinking ,let go the button.Then hold it in again until it shows oil life 100%.Done

SOURCE: How do I reset oil life % change oil message on my

The procedure is as follows:

• Turn ignition to the "ON" position.
  
• Press "SETUP" button.
  
• Press "RESET" button. Press and hold "RESET" button until "IF NEW OIL HOLD RESET" is displayed.
  
• Press and hold "RESET" button until "OIL LIFE RESET TO 100%" is displayed.

SOURCE: How do you reset the 2012 Fiat 500 oil sensor

With all doors closed, put key in ignition and turn key to first position only, and fully depress and release the accelerator pedal 5-7 times. Pedal must be pressed all the way down and fully released these 5-7 times. I hope this helps!