Could you possibly email me a belt routing diagram
My 86 300zx sounds like the blower is on for a while after I turn the engine off. Is there a problem or is that norman? I haven't noticed that before.
Click on the following FREE direct Link. It has the Belt Diagrams for your 1991 Nissan 240SX 2.4L DOHC In-Line 4-Cylinders; along with the various engine options (AC/No AC, etc.).
Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/1991/make/nissan/model/240sx/1991_nissan_240sx_drive_belt_routing_diagram.htm
Well if you have a Ka you should know it has three belts. Alternator belt closest to the engine, then power steering/ ac belt second and finally you have you clutch fan belt
SOURCE: I WOULD LIKE A NISSAN SENTRA 2008 BELT ROUTING DIAGRAM
THERE SOULD BE A DIAGRAM UNDER THE HOOD ON A WHITE STICKER SOMEWHERE IN THE FRONT OF THE MOTOR.HOPE THIS HELPS. LET ME KNOW. GOOD LUCK
SOURCE: need routing diagram for 2000 lincoln town car serpentine belt
There's a diagram at this link.
SOURCE: i NEED 2005 mazda6 Serpentine Belt Routing
There are 2 engines for your Mazda 6, a 2.3 and a 3.0. Below are both diagrams:
2.3
3.0
SOURCE: belt routing diagram 98 zx2 2.0
1) Start with the alternator.
2) Forward to the smooth idler
3) Forward to power steering
4) Down to A/C compressor
5) Back to crank pulley
6) Forward around tensioner
7) Back glancing off of water pump
8) Back glancing off of ribbed idler
9) Up around alternator (where you started)
Good luck!
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
609 views
Usually answered in minutes!
×