Will not shift into gear
SOURCE: 1990 jeep wranger slave cyclinder
The clutch slave cylinder on this model is located inside the transmission bell housing. You would have to pull the tranny to see it.
Bleeding the slave cylinder is a fairly simple process.
Underneath the vehicle on the driver side you will see two hydraulic lines going into the transmission where the tranny connects to the engine. If you have trouble locating just follow the hydraulic line from the master cylinder on the firewall.
One of these lines is actually sticking out of the tranny and has a bleeder valve on the end.
You will need a 9/16 box end wrench and a 5/16 or 1/4 inch box end wrench and someone with you to press the clutch pedal while you are under the vehicle.
1. Top off the master cylinder with clean brake fluid. Also, MAKE SURE you keep the fluid level in the master cylinder topped off during this process. You may need to have a second helper to take care of this so you don't have to keep climbing out from underneath.
2.Hold the line with the 9/16 and loosen the bleeder valve a couple turns or until fluid begins to drain. Have someone SLOWLY depress the clutch pedal to the floor and hold it down to the floor until you tighten the bleeder valve back up. MAKE SURE YOU ARE OUT OF THE WAY OF THE SQUIRTING FLUID WHEN THE PEDAL IS DEPRESSED!!
3. Once you are sure the valve is tight, have them pump the clutch pedal a couple times . Repeat step two until the pedal has a full stroke.
SOURCE: how do I bleed hydraulic clutch in 1991 jeep
There is a bleeder on the drivers side of the transmission follow the tube from the clutch master cylinder if you cannot find it. Pump the clutch up and hold it down then open the bleeder repeat till air is gone. May have to bleed again after driving a bit. If you want to bleed the clutch master cylinder run a tube from where the line goes into the cylinder and take the cap off and run the tube into the fluid (make sure its in the fluid) then pump the clutch slowly until no air bubbles. I just replaced my clutch master cylinder this is where the information comes from hope it helps you out!
SOURCE: 1991 jeep wrangler clutch
U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.
SOURCE: I need to bleed the clutch on my 1992 jeep
The bleeder valve will be on the slave cylinder. Follow the hydraulic line from the Master Clutch cylinder down to the slave cylinder by the transmission.
SOURCE: 1989 jeep wrangler wont shift gear and clutch gone loose
Get the clutch slave cylinder and master cylinder looked at.One of the 2 has failed.If the pedal goes to the floor or is very loose,this is very likely the cause.Not an expensive fix.Hope this helps
Testimonial: "succinct. precise. prompt. thank you so much."
338 views
Usually answered in minutes!
×