- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Remove the headrests. Then slide the cover over the seat back cushion (Photo 5). Push the bottom straps through the gap and into the buckles just like you did on the bottom cushion (refer to Photo 3). Reconnect the bib panel and pull down on the rear portion of the seat back cover to remove wrinkles.
Hi Kathryn, I'm glad to help! CAUTION: If you have "ACTIVE HEADREST" you will want to unhook the negative battery cable. NOTE: You'll also need to take the back of the seat cover off and unplug the connector going to the active headrest. Then simply push the release button on the side of the headrest and pull it upward and out of the seat. "HOWEVER" If you do not have the active headrest, then simply push the release and pull upward out of the seat. Hope this helps and have an awesome day Kathryn.
There is normally a push button for adjusting the headrest height. This is the same button that you use to get it off. Sometimes they pull instead of push but you have to do it while pulling the headrest.
loosen up the cover to the seat and reach into the actual seat from underneath, there should be 2 latches. The closest one at the bottom of the headrest system locks the headrest at the upmost position. If you lift up that latch (as in pull it away from the headrest) the headrest should be easy to just push the rest of the way...
the 605 is an internal Tranny computer failure U will need a
tranny computer no way around it. It will also need to be programed as
well once installed.
90% of head rests just pull out. the others will have a button where the headrest goes into the seat. If yours doesn't have the button, then push the headrest down and **** it up with some force and it will come out. Just be carefull you don't hit yourself in the face with it. Been there done that
Same proceedure as front headrests but tilt the back of the seats forward about halfway. Push the little clip in on top of the seat, by the chrome rail, pull the headrest up and slide out of the hole. Push the back of the seat back, lift up the bottom seat and tilt forward. Lay the back seats down. Done.
There should be a button on the base of the headrest to raise & lower it. Push the button, and lower it. With the button pushed, raise the headrest, and pull hard. They ARE tight.
×