Installed after market stereo with anouther after market stereo worked fine till i went install it in the dash possibly a wire touched something went through fuses and found the cig fuse was blowen replaced it now the cig lighter works but no radio or dome lights now this is a 2002 chevy tracker 4dr 4x4
Could you have forgotten to reconnect the wire harness at the switch?
FREE drawings & TECHNICAL SERVICE Bulletins
can be found (totally FREE) at
BBB Industries Premium Alternators Starters Power Steering Products
You will find registration is required
(these are real manufacturer drawings).
Carnac the Magnificent
SOURCE: new radio installed - now dash lights don't work
Most factory stereos are wired to the dash dimmer switch. Usually if the dash lights go out after an after market stereo installation, it is because the wire that originally went to the factory stereo is not used for after market stereos. Double check the fuses and ensure the wire that controlled the lights on the factory stereo is not grounding out on something.
SOURCE: fuse/circuit breaker for cig.lighter/radio/dash lights
The heavy duty or 'circuit breakers' should be in the engine compartment, perhaps in front of the air breather.There are one or may be 2 inside behind the front side kick panels driver and passenger side, or under the steering wheel.
SOURCE: cig lighter fuse blew. renewed but cig lighter and remote key not
you probably didnt change the right fuse and had another one blown at the same time you also could have a primary fuse under the hood that blew. once fixed dont use pump again. not same amps drawn
SOURCE: 2003 ford escape, fuse keeps blowing for door locks, radio and dome light. y
check for a shorted to ground positive wire repair as nesseacry
542 views
Usually answered in minutes!
×