At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
lost key with chip tried to start with spare key. would't start. found my key with chip .now car won't even turn overlost key with chip tried to start with spare key. would't start. found my key with chip .now car won't even turn over
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
New spark plugs, then new leads and then new coil packs. Maybe crankshaft position sensor in that order.
But the PT 'Crusier' is a heap of brown smelly stuff. You should get rid of it as soon as possible. Look at the Scotty Kilmer YouTube channel and put 'PT Cruiser' into search.
Is this a 4.0 liter or a 2.5 liter wrangler? Sometimes the crankshaft sensor causes these things to make these codes come up. Crankshaft position sensors are very common of going bad on Jeep vehicles.
this normally happens when you have a bad crankshaft sensor or a bad harness, will recommend you to inspect your harness first if this looks ok, then have your crankshaft sensor replaced, this is located on the rear of the engine so have to raise the car and from the bottom you will see a 3 wire connector.
You probably need the egr valve changed or the passages beneath it cleaned of carbon deposits that are blocking up the passage of exhaust gas back into the engine. It's an important emission control device that reduces pollution by lowering combustion temperatures. When they get plugged up, it can cause stalling, so I would have it serviced.
p0340 is camshaft position sensor A-bank 1 curcuit malfunction,
Its
very likely you need a new cam sensor. check wiring also, the cam sensor is not expensive.
change the crankshaft positon sensor in the rear of the engine above the oilfilter. Also check the wiring to this sensor, they have a problem shorting out. You have to change the camshaft and crankshaft sensors at the same time. Make sure you give your car a major tune up. Did you check yor starter?.........runjoe
lost key with chip tried to start with spare key. would't start. found my key with chip .now car won't even turn over
×