- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
yes its more less the pvc valve shoud be located some wherer around the frunt side are the left side of the valve cover screw out and shake it a little to see if you here the bead in it move you should hear iit if not use a littl gas in it to clean it let dry than put back in if not get a new one few bucks and save you alot in the long run
Check the Mass Air Flow Sensor, you can get a can of cleaner specific for cleaning them for a couple bucks at the parts store. I'd just get 1 and clean the sensor see if that works. The MAF sensor is either in the throttle body itself (bolted on from the outside or in the air line between the filter and throttle body. That could be the whole problem right there. Good luck.
Check the vacuum line under and in front of the throttle body...with engine idling. It is located under where the air filter snorkel attaches to the engine. Then check all vacuum lines at the intake manifold. Check vacuum lines at distribution block on firewall and check the large brake booster vacuum line from one end to the other. You'll find it!
Code 66 it's a TCM a Transmission Control Module. It could be that
might not be it could be lose wire on your relay for your TCM most
common it could be a relay going bad for the TCM it could be a input
sensor or a out put sensor that is located on your transmission it could
also be your transmission solenoid pack needs to be replaced on your
transmission or could be a bad IDC which is vavle Idle Air Control that
is located on your Trottle Body beside your trottle sensor. First think I
would do is get a diganostic test done most likely your software needs
to be updated.
The trottle body is located on the intake manifold. There will be a black tube going to it. This tube is the breather tube and on the opposite end is the air filter and it container. You trottle cable and cruise control cable will also be attached to it. If you are unsure of its location, have a friend get inside the car and work the gas peddle. While you are looking at the top of the moter, you should see the linkage at the trottle body moving. Tha linkage is part of the trottle body.
It is probabley worn rings so the best thing to do is at next oil change get a can of V-8 formula engine restore it takes the place of about half a quart of oil I think to be exact I think the restore for a V-8 is a 15 ounce can.Try that at oil changes.
×